User manual BERTAZZONI K36CONX

[. . . ] To assure this condition, make openings in the room which cannot be closed (doors, windows, etc. Are not sufficient) and through which the air necessary for combustion can freely flow. Note: All the exhaust ductwork in the apartment or house should be studied. In case of doubts, get advice or authorisation from the person or agency responsible for the building. [. . . ] Attention: The panel should be fitted (if supplied) over the body after installation and fixed from the outside using the special screws, washer and cover provided (Fig. Some models could be supplied only with 2 external and 2 internal fixing points with relevant nuts (Fig. Electric connection Make sure the supply voltage ratings correspond with those stated on the appliance data plate. Attention: The appliance is provided with a supply cord and plug, the appliances must be positioned so that the plug is accessible. Attention: if there are three wires in the electrical supply cable they must be connected as follows: Green/yellow = ground --White = neutral --Black = line Important: the hood manufacturer will not be responsible for any damage or loss caused by failure to observe these instructions. Important: a damaged power supply cord must be replaced by the service. Using the cooker hood The cooker hood should be switched on either before or at the same as cooking or frying commences. The filters are more effective if the fan is not switched off immediately after cooking or frying is completed, but only after a period of some 20-30 minutes. Before using the cooker hood please ensure that all plastic films like on metal grease filter a stainless steel ducting are removed. user instructions The cooker hood is supplied with Multicolour operation panel (Fig. 3) that works in the following way: 0/1-2-3 Speed Switches L - Light Switch T - Timer The Timer will run if the Timer switch is pushed and will stop running the cooker hood after 5 minutes. operation light and function of saturation indication for the filters The saturation of the grease filter will be indicated by the operation LED. By switch off cooker hood and pushing the bottom T the operation LED will indicate different colours with following meanings: Green Light: less than 6 working hours Yellow Light: between 6 and 12 working hours Red Light: more than 12 working hours (the grease filter should be cleaned or eventual changed) To re-set the Timer, once the hood is switched-off, push for more than 5 seconds the bottom T. Lamp Replacement The hood has a halogen lamp, take care to not touch it with your hands when you replace it. Use a dry and not greasy protection (for example a cloth) in order to avoid a direct contact with skin that could make the lamp break. Never use lamps with wattage higher than the one shown on the label inside the hood. When frying, never leave the pan alone because the cooking oil could flare up. Done with a cloth or/and with a brush drenched with denatured alcohol or with any other similar substances, except for the button area (Fig. [. . . ] Always turn hood ON when cooking at high heat or when flambeing food (i. Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. [. . . ]