User manual BERNEX GB31103 CATALOGUE 2010

[. . . ] Documentation Classifications In order to assist in the use of this product, BERNEX provides the following types of documentations:  For quick set-up of the product, read the Quick Installation Guide included with the product. ρ® For detailed product information, carefully read the User's Manual. Com Identifying Your Motherboard Revision The revision number on your motherboard looks like this: "REV: X. Check your motherboard revision before updating motherboard BIOS, drivers, or when looking for technical information. [. . . ] If this item is set to Disabled, the HS Port #1/2/3/4 Switchable and xHCI Streams items below will become unconfigurable. 0 device attached on this port with Super-Speed capability is visible to xHCI controller. 0 device attached on this port with Super-Speed capability will function as High-Speed. 0 Streams support, devices may require UASP class driver updates from UASP driver vendors to be fully compatible with Intel USB 3. (Default: Enabled) If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item to Disabled. Specifes the frst initiation of the monitor display from the installed PCI graphics card, PCI Express graphics card, or the onboard graphics. PEG Sets the PCI Express graphics card on the PCIEX16 slot as the first display. (Default: 64M) Allows you to allocate the DVMT memory size of the onboard graphics. (Default: Disabled) & Internal Graphics & Internal Graphics Memory Size & DVMT Total Memory Size & Intel(R) Rapid Start Technology & Legacy USB Support & XHCI Hand-off & EHCI Hand-off Allows USB keyboard/mouse to be used in MS-DOS. (Default: Enabled) Determines whether to enable XHCI Hand-off feature for an operating system without XHCI Hand-off support. (Default: Enabled) Determines whether to enable EHCI Hand-off feature for an operating system without EHCI Hand-off support. (Default) Delay 4 Sec Press and hold the power button for 4 seconds to turn off the system. If the power button is pressed for less than 4 seconds, the system will enter suspend mode. & Internal Graphics Standby Mode & Internal Graphics Deep Standby Mode Allows you to determine whether to let the onboard graphics enter standby mode to decrease power consumption. (Default: Enabled) Allows you to determine whether to let the onboard graphics enter deeper standby mode. This exits the BIOS Setup without saving the changes made in BIOS Setup to the CMOS. & Load Optimized Defaults Press <Enter> on this item and select Yes to load the optimal BIOS default settings. The BIOS defaults settings help the system to operate in optimum state. Always load the Optimized defaults after updating the BIOS or after clearing the CMOS values. & Boot Override Allows you to select a device to boot immediately. Press <Enter> on the device you select and select Yes to confirm. & Save Profiles & Load Profiles This function allows you to save the current BIOS settings to a profile. [. . . ] Make sure the motherboard does not short-circuit with the chassis or other metal objects. Is the power connector of the CPU cooler connected to the CPU_FAN header properly?Make sure the graphics card is securely seated in the expansion slot and power connectors are firmly attached. ) - 97 - Appendix A When the computer is turned on, is the CPU cooler running? [. . . ]