User manual BELSON MH2027

[. . . ] 4) This page includes useful tips to help you load your dishwasher correctly and make the most of all the available space. 5) After loading the dishes, you need to select the right wash cycle and measure out the correct dose of detergent and rinse aid. 9) Before washing anything in the dishwasher check the information provided by this section. 6) Learn the right usage of detergent and rinse aid for best washing results. [. . . ] To select the wash cycle, turn knob "D" clockwise until the reference notch on the knob corresponds with the number or symbol for the cycle you wish to set (have a look at the wash cycle table on page 7). After a few seconds, you will hear a short beep: the wash cycle has begun and we do not recommend you change it. Your dishwasher is fitted with indicator lights (G) which light up to indicate the cycle phase under way. At all times, your dishwasher tells you which cycle phase is under way. You can modify the wash cycle in progress, if it has only just started. Turn the knob counter clockwise until it reaches the Reset position and, after a few seconds, you will hear 4 beeps and indicator light "G" will turn off. The wash cycle stops and then restarts when the electricity comes back on or when you shut the door. You can cancel the wash cycle in progress, if it has only just started. If opening the door soon after the end of the program, or during it, stand away from the Dishwasher, to avoid possible injury from hot steam. The detergent should be poured into the two containers C and D up to the rim. If you prefer to use the detergent in tablets, place one of these in container "D". Never without salt Water hardness varies according to where you live. If the water in your home is hard you have the possibility to add salt in order to soften your water. The softer the water the better will be your washing and drying results. If the 3rd light from the right flashes rapidly, turn the dishwasher off and back on again after one minute. If the alarm persists, first turn off the water tap to avoid any flooding and then cut off the electricity supply and call for technical assistance. S Is the wash cycle suitable for the dishes you have placed inside the appliance?Your dishwasher is equipped with a safety system which is able to detect any operating problems. These anomalies are reported by one or two wash cycle indicator lights "G" will flash rapidly. Take a note of which lights are flashing, turn the appliance off and call for technical assistance. Clogged filter alarm Tap off alarm If you have forgotten to turn the water tap on, your appliance will If the appliance is blocked and the 2nd and the 4th light from the right flash rapidly, this means the filter is clogged by large particles of food residue. Turn the appliance off, clean the filter thoroughly and reposition it in its seat as illustrated on page 10. [. . . ] When the wash cycle has ended, always remenber to leave the appliance door ajar. Before carrying out any cleaning or maintenance on the dishwasher, always remove the plug from the electricity socket. To clean the exterior and rubber parts of your appliance, do not use solvents or abrasive cleaning products. If there are any stains on the surface of the appliance interior, use a cloth dampened with water and a little white vinegar, or a cleaning product specifically made for dishwashers. [. . . ]