User manual BELL AUDIO PA-2022 DATASHEET

[. . . ] Phantom Power +48V (Switch w/indicator in the Master section) When using phantom powered condenser microphones, 'phantom power' should be switched 'on'. Channel Level control should be turned down (ccw), when operating the 'phantom power' switch. [. . . ] When using only dynamic microphones, 'phantom power' should be switched off. Mono Input Channels 1-8 / Line Jack Sockets These inputs are for use with monaural line signals, such as musical instruments, keyboards etc. Warning: any extreme setting (more than +3dB) of any tone control should generally not be necessary with any good speaker system. EFX works 'post fader' and will fade up and down with the Channel LEVEL control. Use the Monitor (MON) feature to control external powered monitor loudspeakers or power amplifiers. Setting PAN fully CCW will send the signal only to the left mixing bus. These equalizers should be used for fine control of the overall sound only. The normal EQ setting with good speaker systems should be around +-3dB max. The built-in multieffect unit The integrated multieffect unit is prohrammed with 256 effects, such as reverb, stereo delay and many others. the send function is determined by the EFX 16 BIT DIGITAL MULTI EFFECT controls in the input channels. In case of any MODE overload condition, the red PEAK LED will illuminate. In this case, the input signal of the multieffect unit must be lowered by turning the EFFECT SEND control slightly counterclockwise. [. . . ] In case of any MODE overload condition, the red PEAK LED will illuminate. In this case, the input signal of the multieffect unit must be lowered by turning the EFFECT SEND control slightly counterclockwise. [. . . ]