User manual BELKIN TUNEBASE FM WITH HANDS-FREE

[. . . ] Push down on the top of the springboard until it holds your iPod securely in place. Note: After you have adjusted the height of the springboard, there is no need to adjust the TuneBase to insert and remove your iPod. Warning: Do not remove the TuneBase from the cigarette lighter adapter when an iPod is in the cradle. Do not position your TuneBase as follows: Remove your iPod from your TuneBase 1. [. . . ] If the volume remains too faint, increase the volume on your iPod to boost the signal. Charge other UsB devices Use the USB port on the bottom of the TuneBase to charge USB-powered devices such as MP3 players and GPS units. Warning: To prevent damage to your TuneBase, turn off your car stereo and TuneBase before connecting an audio cable. Use the Pro Button to Boost sound If you find the sound is too weak, press "PRO" to boost the sound coming from your iPod. PRO will cycle through the following settings: Use All types of audio Most types of music Quieter music Description No change to audio Increases the average volume of the audio Increases the average volume more than PRO 1; may cause distortion of louder music Increases the average volume and transmits in mono Phone calls, mono recordings, audio books, podcasts Try this if you do not receive a clear signal You can quickly solve most problems with your TuneBase by following the advice in this section. solution · PositionyouriPhonesothatitsscreen is facing toward you and away from your car's speakers. Your TuneBase and iPod are in the way of your vehicle's controls. MakesureyourTuneBasehasagood connection to your car's power outlet. Use the flexible gooseneck and the articulation behind the docking cradle to position your TuneBase away from your vehicle's controls. Some vehicles do not provide power to the power outlet unless the vehicle is in ignition mode or the engine is running. Your TuneBase rotates out of position around the center of the power outlet. Solution 1 Be sure to solidly attach the cigarette lighter adapter of the TuneBase to the power outlet. Solution 2 In some vehicles, the power outlet is wider than the cigarette lighter adapter of the TuneBase. In that case, slide the fit ring around the cigarette lighter adapter of the TuneBase. Then, insert the cigarette lighter adapter into the power outlet, making sure that all four prongs of the fit ring securely fit in the power outlet. If the fit is too tight, you can cut off one or more of the prongs on the fit ring and try the fit again (see Solution 3). Solution 3 The fit ring may be too large for some cars' power adapters. Your TuneBase connects firmly to the power outlet, but it still rotates. The rubber friction washer remained in the power outlet when you removed your TuneBase. Solution This is rare, but if it occurs you can remove the rubber washer from the power outlet and place it back on the cigarette lighter adapter. Any attempt to remove the washer without disconnecting the battery may result in physical harm to you or damage to the vehicle. Use pliers to carefully remove the friction washer from the power outlet. [. . . ] Belkin will repair or replace, at its option, any defective product free of charge (except for shipping charges for the product). Belkin reserves the right to discontinue any of its products without notice, and disclaims any limited warranty to repair or replace any such discontinued products. In the event that Belkin is unable to repair or replace the product (for example, because it has been discontinued), Belkin will offer either a refund or a credit toward the purchase of another product from Belkin. Com in an amount equal to the purchase price of the product as evidenced on the original purchase receipt as discounted by its natural use. [. . . ]