User manual BELKIN SURF N750

[. . . ] WIRELESS DUAL-BAND N+ ROUTER N750 DB User Manual F9K1103  8820-00778 Rev. 27 Restoring the Router to Default Settings Using the Web Interface . 44 Getting Started What’s in the Box N750 DB Wireless Dual-Band N+ Router Ethernet cable (attached to router) Power supply (attached to router) Network information card (attached to router) Belkin Setup CD with User Manual Initial Setup Where to Place Your Router For the best results, place the Router next to your modem in an open location away from large metal objects and magnets such as those found in speakers. Raising the Router above floor level can improve the strength of your wireless signal. 1 Getting Started How to Set It Up 1 modem 2 3 2 Getting Started 1. Connect your Router’s Ethernet cable to your modem’s Ethernet port (on the back of your modem). [. . . ] Note: This may take several minutes. Your Router has successfully been restored to its factory settings. 6. A warning box will open that says, “Warning: All your settings will be lost. Are you sure you want to do this?” Click “OK”. 30 Troubleshooting, Support, and Warranty Troubleshooting The Setup CD does not automatically start. If Belkin Setup does not run when you insert the CD-ROM, your computer may not be configured to open CDs automatically. If Belkin Setup does not appear within 15 seconds, browse to your CD-ROM drive and open the “Belkin Setup” icon. Alternatively, you may visit http://router/ and perform the setup manually. Please see “Manual Setup Using Your Browser” earlier in this manual for more information. Belkin Setup cannot find my Router. If Belkin Setup is not able to communicate with your Router during the installation process, please check the following items. 1. Make sure that the wireless hardware on your computer is turned on, if available. 2. Try connecting your computer to one of the four “wired” ports on the Router with an Ethernet cable. 4. Unplug the Router’s power supply for 10 seconds, then plug it back in. 5. There may be firewall software on your computer preventing an outgoing connection. You may choose to temporarily disable this software before attempting setup. If Belkin Setup still cannot find the Router, you might choose to do a manual setup. Refer to “Manually Configuring Network Settings” in this manual for details. 31 Troubleshooting, Support, and Warranty Belkin Setup cannot connect my Router to the Internet. If Belkin Setup is not able to connect the Router to the Internet, please check the following items: 1. Use the troubleshooting suggestions within Belkin Setup. 2. If your ISP requires a user name and password, make sure that you have typed in your user name and password correctly. Some user names require that the ISP’s domain may be at the end of the name. The “@myisp. com” part of the user name may need to be typed as well as your user name. 3. If you continue to have no Internet connection, refer to “Manually Configuring Network Settings” in this manual for an alternative setup method. Belkin Setup completed installation, but I cannot browse the Web. 1. Make sure the Router is connected to your modem with an Ethernet cable via the Router’s one WAN (modem) port. 2. Unplug the modem from its power source and make sure that it goes dark. [. . . ] All costs of shipping the Belkin product to Belkin for inspection shall be borne solely by the purchaser. If Belkin determines, in its sole discretion, that it is impractical to ship the damaged equipment to Belkin, Belkin may designate, in its sole discretion, an equipment repair facility to inspect and estimate the cost to repair such equipment. The cost, if any, of shipping the equipment to and from such repair facility and of such estimate shall be borne solely by the purchaser. Damaged equipment must remain available for inspection until the claim is finalized. [. . . ]