User manual BELKIN N600

[. . . ] PLAY N600 WIRELESS DUAL-BAND N ROUTER User Manual F7D8302 8820-00700 Table Of Contents Getting Started . 34 Getting Started What’s in the Box Play N600 Wireless Dual-Band N Router Ethernet cable (attached to router) Power supply (attached to router) Network information card (attached to router) Belkin Setup CD with User Manual Initial Setup Where to Place Your Router For the best results, place the Router next to your modem in an open location away from large metal objects and magnets such as those found in speakers. Raising the Router above floor level can improve the strength of your wireless signal. 1 GeTTInG sTaRTeD how to set It Up 1 modem 2 3 2 GeTTInG sTaRTeD 1 . Connect your Router’s Ethernet cable to your modem’s Ethernet port (on the back of your modem) . [. . . ] Some user names require that the ISP’s domain may be at the end of the name. The “@myisp. com” part of the user name may need to be typed as well as your user name. 3. If you continue to have no Internet connection, refer to “Manually Configuring Network Settings” in this manual for an alternative setup method. Belkin Setup completed installation, but I cannot browse the Web. 1. Make sure the Router is connected to your modem with an Ethernet cable via the Router’s one WAN (modem) port. 2. Unplug the modem from its power source and make sure that it goes dark. 3. Unplug your Router’s power supply, wait 10 seconds, and plug it back in. This will cause the Router to try to reestablish communication with the modem. 22 Troubleshooting, Support, and Warranty Belkin Setup completed installation, but I cannot browse the Web. 2. If your ISP requires a user name and password, make sure that you have typed in your user name and password correctly. Some user names require that the ISP’s domain may be at the end of the name. The “@myisp. com” part of the user name may need to be typed as well as your user name. 3. If you have a static connection, your ISP will have assigned you an IP address, subnet mask, and gateway address. Please re-run Belkin Setup and enter this information when a static connection is mentioned. 4. You may need to configure your Router to meet the specific requirements of your ISP. To search our knowledge base for ISP-specific issues, go to: http://www. belkin. com/support and type in “ISP”. 5. If you continue to have no Internet connection, refer to “Manually Configuring Network Settings” in this manual for an alternative setup method. I can’t connect to the Internet wirelessly. If the light on the front of the Router is solid green, then your Router is connected to the Internet. Please refer to “Adding Computers to Your Network” in this manual for instructions. 23 Troubleshooting, Support, and Warranty I can’t connect to the Internet wirelessly and my network name is not listed in Available Networks. 1. Verify that your Router is on and the front-panel light shows solid green. 2. If you are far from the Router, you might try moving closer to see if you might have been out of range. 3. Using a computer attached to the Router via a network cable, visit http://router/ and ensure that “Broadcast SSID” is ON. This setting is found on the “Channel and SSID” page. My wireless network per formance is slow, inconsistent, suffers from weak signal, or I’m having difficulty maintaining a VPN connection. Wireless technology is radio-based, which means connectivity and the throughput performance between devices decreases when the distance between devices increases. [. . . ] Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. IN NO EVENT SHALL BELKIN BE LIABLE FOR INCIDENTAL, SPECIAL, DIRECT, INDIRECT, CONSEQUENTIAL OR MULTIPLE DAMAGES SUCH AS, BUT NOT LIMITED TO, LOST BUSINESS OR PROFITS ARISING OUT OF THE SALE OR USE OF ANY BELKIN PRODUCT, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. This warranty gives you specific legal rights, and you may also have other rights, which may vary from state to state. Some states do not allow the exclusion or limitation of incidental, consequential, or other damages, so the above limitations may not apply to you. 33 Regulatory Information FCC Statement DECLARATION OF CONFORMITY WITH FCC RULES FOR ELECTROMAGNETIC COMPATIBILITY We, Belkin International, Inc. , of 12045 Waterfront Drive, Los Angeles, CA 90094, declare under our sole responsibility that the device, , F7D8302 v1, complies with Part 15 of the FCC Rules. [. . . ]