User manual BELKIN HI-SPEED USB 2.0 EXTERNAL DRIVE ENCLOSURE

[. . . ] If you are installing a CD/CD-RW drive, check to make sure your drive is set to "Master", then connect the 34-position data cable, 4-position power cable, and 4-position audio cable. Choose the set of mounting holes that match the drive you intend to use, and install at least four of the provided mounting screws. Note: There are four fine-threaded screws, and four course-threaded screws included with your Hi-Speed External Drive Enclosure Kit. Be sure to choose the screws that match the mounting holes for your drive. [. . . ] Your new drive will now appear in the "My Computer" window as a "USB Disk". Note: If the new drive does not appear in My Computer, you may need to partition and format the drive. Click the green "Unplug or Eject Hardware" icon in the system tray and select the device that you want to remove. When the system prompts "You may safely remove this device", unplug the USB cable from the USB port of your computer. 0 External Drive that you want to disconnect, then click on "Stop" again. When the system prompts "You may safely remove this device", unplug the USB cable from the USB port of your computer. Your new hard disk will appear in the hard drive list (in this case as "Toshiba 1924FCV"). Make sure there are check marks in the "Disconnect", "Sync Data Transfer", "Removable", and "Int 13 unit" boxes. After making these changes, it will be necessary to restart your computer. Note: Using this method to format your removable hard drive will result in a single partition equal in size to the maximum rated capacity of your hard disk. Note: If the FDISK utility terminates without displaying an error message, exit back to Windows and disconnect the External Drive. When Windows restarts, reconnect the External Drive and go back to Step 1. In the opening FDISK screen, answer the question: "Do you want to enable large disk support?" Enter "Y" if you want to create a partition larger than 2GB. Enter "N" if you want to create a partition smaller than 2GB. In the "Change Current Fixed Disk Drive" screen, enter the disk drive number that is assigned to your External Drive. Be sure that you select option 5 and change the "Current Fixed Disk" from "Disk 1" to the disk number assigned to your External Drive. If your computer is equipped with only one internal drive, your new External Drive will be identified as "Disk 2". If your computer is equipped with two internal disk drives, your new External Drive will be identified as "Disk 3". Failure to follow this step will result in the loss of all data on your primary internal hard disk. [. . . ] Belkin Corporation warrants this product against defects in materials and workmanship for its lifetime. If a defect is discovered, Belkin will, at its option, repair or replace the product at no charge provided it is returned during the warranty period, with transportation charges prepaid, to the authorized Belkin dealer from whom you purchased the product. This warranty does not apply if the product has been damaged by accident, abuse, misuse, or misapplication; if the product has been modified without the written permission of Belkin; or if any Belkin serial number has been removed or defaced. No Belkin dealer, agent, or employee is authorized to make any modification, extension, or addition to this warranty. [. . . ]