User manual BELKIN F6C.B550.750AVR

[. . . ] These materials are invaluable if you ever have to return the UPS for service. Federal Communications Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] BATTERY REPLACEMENT PROCEDURE Replacement requires removing the battery cover plate on the back or bottom of the UPS. Press fastener to remove the battery cover plate on the back of the UPS (Fig. 2) Remove the battery then insert a new battery pack, and push the connectors onto the battery terminals (black to black & red to red)(Fig. 3) NOTE: There may be a small spark at the battery terminals when reconnecting the connectors. 1). 4. FAULT/ *OVERLOAD/ *Replace Battery (Red Led) Solid Red Fig. Connect to AC Utility Power Connect the AC inlet to utility power via the power cord. Charging the Battery For best results, charge the battery for 8 hours prior to initial use. To fully utilize the Bulldog Plus Shutdown Software; you will need to connect the UPS to your computer. Use the ON/OFF/TEST UPS power switch function to schedule UPS for power saving Using the USB cable (provided), connect the cable to your UPS then connect the other end to the USB port on your computer. Caution: Use only the factory-supplied UPS monitoring cable. Software Installation (Installation Optional) To fully utilize the UPS and its software, your computer must be able to operate the following operating systems: Windows98/ ME/ NT4/ 2000 / 2003/ XP and have a USB port. This allows you to protect and save your data should a power outage occur, as well as safely shutdown your computer in your absence. Please be sure to close out of all applications prior to installing the software. To install the software, please place the CD into the CD drive of your computer. If this does not occur, go to the Run feature on your Start icon (lower left corner) on your screen. Please enter the CD drive, it may be D: Upon entering the drive run setup. exe. Should you continue to have a problem, please refer to your computer's owner's manual for the correct drive. The "Welcome to the Belkin Bulldog Plus Product Installation Browser" will appear. Networking management is for administrators who need to manage several UPSes in a workstation environment. You should not install the networking files unless you are technically qualified to use these features. For more information on networking, please refer to the software user's manual. On Choose Destination Folder, you have the option to choose the location of where you would like the Software located on your computer. On Select Program Folder, you have the option to choose the program folder for your Software. To access this screen, please click the Belkin shield found in the lower right corner on your task bar of your screen. [. . . ] The license is governed by the laws prevailing in the State of New York, without regard to its conflicts of laws principles. ACKNOWLEDGMENT: By opening the package on which this Agreement is printed, or through which it is visible, you acknowledge that you have read this Agreement, understand it, and agree that this agreement is the complete and exclusive statement of agreement between yourself and Belkin and supersedes any prior agreements, oral or written, and any other communications relating to the subject matter of this Agreement. SEVERABILITY: Any term or provision of this Agreement or any application thereof, which may be prohibited or unenforceable by law in a particular jurisdiction, shall be interpreted and enforced to the maximum extent allowed in such jurisdiction (which the parties acknowledge could mean severing the provision from this Agreement or, if allowed, enforcing it in a narrower form), without affecting the remainder of this Agreement, or any other application of such term or provision in such jurisdiction, or application of such term or provision in any jurisdiction. The unit is intended for installation in a controlled environment (temperature controlled, indoor area free of conductive contaminants). [. . . ]