User manual BELKIN F5D6050

[. . . ] Wireless USB Network Adapter User Manual F5D6050 Table of Contents Introduction . 3 Quick Setup ­ Setting up your Belkin Wireless USB Network Adapter . 32-33 Introduction Thank You for purchasing the Belkin Wireless USB Network Adapter (the Adapter). Now you can take advantage of this great new technology and gain the freedom you need around the home or office without using cables. [. . . ] If you have more computers that you need to set up to work with the wireless network, click "Yes". This will save some setup files to a disk, simplifying setup of subsequent computers. If you are not going to set up any more computers, click "No" and move to step 11. If you clicked "Yes", you will be prompted to insert a floppy disk into the PC's floppy disk drive. Label a floppy disk "Belkin Networking" and insert it into the floppy disk drive. After the client setup disk has been created, you will be prompted to restart your computer. Please restart your computer. 19 Installing the Belkin Wireless USB Adapter Manager Now that the first computer has been configured, we are ready to configure the other PCs on your network. Click "Start", "Programs", "Belkin SOHO Networking", and then "Belkin NetSetup" to launch the easy-to-use computer configurator. Windows will now prompt you to insert the newly created client setup disk into the PC's floppy drive. Insert the disk you labeled "Belkin Networking" into the floppy drive and click "OK". In the "Computer Name" field, type a name for the computer such as "Computer 2". Remember, the name must be different from that of the other computers on the network. The "Workgroup" field should be filled in with the workgroup name you entered on the previous computer. This can be anything you want and does not have to be different from or the same as the description of any other computer on the network. You may also leave this field blank. 20 Installing the Belkin Wireless USB Adapter Manager 7. If you want to share files and printers on this computer, select "I want to share files and printers on my computer" and click "Finish". If not, select "I do not want to share files and printers on my computer" and click "Finish". Repeat these steps for the rest of the computers on your network. 21 Configuring Network Settings for Windows 2000 1. Right-click on "My Network Places" and select "Properties". In the "Network and Dial-up Connections" window, "Local Area Connection" should be available. Right-click on "Local Area Connection" and select "Properties". 4. Highlight "Internet Protocol (TCP/IP)" and click on "Properties". [. . . ] In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8inches) during normal operation. Federal Communications Commission Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. [. . . ]