User manual BELKIN F5C500

[. . . ] Instead of running a connection directly from your Phone/Fax/Modem to the wall jack, you must pass the connection through the protected jacks on your ReSource®. Connect your phone/fax/modem line from your wall outlet to the "Input" jack on ReSource®. Connect the 6-foot phone cord provided with ReSource® into the "Output" jack, and connect the other end of the phone cord to the Phone/Fax/Modem jack of the device you want to protect. If you fail to connect the Phone/Fax/Modem protection your connected equipment will not be covered by the Connected Equipment Warranty. [. . . ] Connecting a Belkin ReSource® to an improperly grounded outlet will void all Belkin Components warranties. Do not attempt to use a "3 prong to 2 prong with ground screw adapter" to bypass the ground pin as this will void all Belkin Components warranties as well. Installing Shutdown Software Shutdown Software - This software closes all open files and saves them during a power failure. To install: · Charge ReSource® 2-4 hours before installing software. · Wait for (RUPS for Windows® 95/98 Setup) to appear on screen. Please check UPS cable, then restart Windows) appears on screen, check RS232 cable to see whether it is connected securely and properly. Other Features 1. 15 amp Circuit Breaker - Located above the main power switch and recessed for safety. To restore power simply unplug one piece of equipment and push the circuit breaker button in. If not, consult the Amperage ratings on the connected devices and confirm that they do not exceed 15 amps total. Usually computers are 1-4 amps, fax machines 1-3, and most devices are below 2. 10Base-T Network Protection - Protects against surges coming through the network RJ45 line and damaging your computer. Solid State Phone/Fax/Modem Protection - Maximum protection for your RJ11 line. ReSource® uses a solid-state-sidactor which provides maximum protection with twice the clamping speed of an MOV. Full Time Surge Suppression - ReSource® provides 1260 Joules of 3 line AC surge protection on all 8 outlets. Surge protection is always there, even if the main power is switched off. Instant Back-Up Power Supply - 4 outlets are labeled as back-up power supply. Do not plug any devices into these outlets that are not critical when utility power is cut. The more devices powered by the battery, the shorter the back-up time. If possible, only plug your monitor and PC into these outlets and save the rest for emergencies. Troubleshooting Symptom ReSource® will not stay powered long enough to save and close. Outlet that ReSource® is plugged into is not properly grounded or has polarity crossed. The voltage in the building is bad, or there is a heavy load on the outlet ReSource® is connected to. Solution 1. Try another outlet in the area, if results are the same, call an electrician to check the wiring of the building. Plug ReSource® into an outlet that does not have a heavy load (heavy load means an air conditioner or a refrigerator are on the same circuit as that outlet). Have an electrician check to see if your power supply is bad, if so, a line conditioner may be required. [. . . ] This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damage, so the above limitations may not apply to you. This warranty is valid only for the original purchaser of the product. The original purchaser must complete and return the attached warranty card within 15 days of the date of purchase or the warranty is void. [. . . ]