User manual BEHRINGER XM1800S

[. . . ] XM1800S Users Manual Version 1. 1 June 2003 DYNAMIC MICROPHONE ENGLISH DYNAMIC MICROPHONE XM1800S 1. SAFETY PRECAUTIONS Detailed safety precautions: Please read all safety precautions and operating instructions before you attempt to operate the unit. [. . . ] AUDIO CONNECTION Use a standard microphone cable to connect your XM1800S to any mixer, power mixer, amp, or mic preamp. Connect the female XLR end to the XM1800S male XLR input connector and the other end of the cable, normally a male XLR connector, to the mixer, power mixer, amp, or mic preamp. Fig. HOW TO USE YOUR XM1800S MOST EFFECTIVELY Adjust the gain control in the microphone channel of your mixing console so that the peak LED lights up only occasionally or never at all. The EQ controls in the microphone channel should be set to mid-travel position to start with; low-cut filter and level attenuator should be turned off. Try to achieve the desired sound by experimenting with the microphone position. The closer your mic gets to the sound source, the greater the bass response will be. On the other hand, as you move the sound source further away from the microphone, the bass response will gradually roll off (please see frequency response chart on next page). Only when the desired basic sound has been achieved, should you start to use equalizers and signal processors, if any at all. (Remember: less is often more!) All microphones have characteristic polar patterns that determine how well signals from around the area of the microphone are accepted or rejected. Thus, the XM1800S excels in environments where a lot of undesired ambient noise exists. The XM1800S excellently reproduces those sound signals originated directly in front of the microphone while rejecting or minimizing sound signals originated in the area behind the microphone (please refer to the polar pattern on next page for detailed information). 5. WARRANTY + Please find our current warranty terms on our web site under http://www. behringer. com or send us a request by e-mail (support@behringer. de), fax (+49 2154 9206 4199), or telephone (+49 2154 9206 4166). 6. [. . . ] The information contained in this sheet is subject to change without notice. No part of this sheet may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording of any kind, for any purpose, without the express written permission of BEHRINGER Spezielle Studiotechnik GmbH. [. . . ]