User manual BEHRINGER UMA25S

[. . . ] UMA25S User Manual A50-50233-00001 U-CONTROL U-CONTROL UMA25S Important safety instructions 10) Place the power cord so that it is protected from being walked on and sharp edges. Be sure that the power cord is protected particularly at plugs, convenience receptacles and the point where it exits from the apparatus. 11) The apparatus shall be connected to a MAINS socket outlet with a protective earthing connection. 12) Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. [. . . ] You simply have to press the MMC push button (LED lights up) before activating Edit Mode. 6. 5. 3 Assignment of control elements using the Learn function The easiest way to assign MIDI functions to individual control elements is to use the Learn function over remote assignment. For example, MIDI data sent from a MIDI sequencer to your U-CONTROL are assigned to a control element in advance. Not only CC, NRPN and Note messages can be received with the Learn function, but almost any type of MIDI data including short SysEx strings. Operate the control element that is supposed to learn the MIDI function. "Lrn" appears on the display while the MIDI device waits for an external MIDI message. Transmit the MIDI message to the UMA25S from the device you want to control. If valid MIDI data are received, the display shows "Gd!" (good). If invalid, incorrect or too long, "Err" (error) appears on the display. Alternatively, press the EDIT/EXIT push button to cancel the changes made. 7a. If you want to store the settings permanently, save them in a preset (see Chapter 5. 1. 2). 5. UMA25S as USB/MIDI controller 13 U-CONTROL UMA25S E9 E10 E11 E12 E13 E14 E15 E16 Example of the Learn function: In order to control the main volume level of a virtual instrument with the E19 slider, follow the steps below: 1. Now move the volume control of the software instrument with your computer's mouse. To save these settings, store them in a preset. MIDI MIDI Value Value Controller Controller Display Data Send Parameter 1 2 Mode Option Value Type Channel Table 5. 1: General assingment of rotary knobs in Edit Mode MIDI Data Type: The E9 rotary knob lets you select the message type that is to be assigned to a control element. MIDI Send Channel: The E10 rotary knob allows you to select the MIDI channel on which the message is supposed to be sent. When Channel 0 is selected, the message is sent on the GLOBAL SEND CHANNEL (see Chapter 5. 7). Parameter, Value 1, Value 2: The rotary knobs E11 to E13 allow you to adjust the parameters and the corresponding values of the selected MIDI message. Controller Mode: The E14 rotary knob is provided to determine the switch behavior of the selected control element. The control push buttons support the controller modes "Toggle On", "Toggle Off" and "Increment". Toggle On is comparable to a switching function (for example, the light switch of a room). The "On" value, which is specified with the E12 rotary knob (value 1), is sent by pressing the push button the first time. Press the push button a second time to send the "Off" value, which is specified with the E13 rotary knob (value 2). [. . . ] Any product deemed eligible for repair or replacement under the terms of this warranty will be repaired or replaced. If the product needs to be modified or adapted in order to comply with applicable technical or safety standards on a national or local level, in any country which is not the country for which the product was originally developed and manufactured, this modification/adaptation shall not be considered a defect in materials or workmanship. The warranty does not cover any such modification/adaptation, irrespective of whether it was carried out properly or not. Under the terms of this warranty, BEHRINGER shall not be held responsible for any cost resulting from such a modification/adaptation. [. . . ]