User manual BEHRINGER PMP2000

[. . . ] PMP2000 User Manual Version 1. 2 May 2007 EUROPOWER EUROPOWER PMP2000 IMPORTANT SAFETY INSTRUCTIONS 12) Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. 14) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain and moisture. [. . . ] The upper LED (LIM) lights up when the built-in limiter is activated, thus protecting against signal peaks. Use the FX FOOTSW(itch) jack to connect any commercially available foot controller. These two 1/4" TS jacks allow you to route the output signal to an external amplifier. This allows you to, say, use only the mixing and effect section of the PMP2000. These two 1/4" TS jacks can be used to connect external signals, such as the main mix signal from an additional mixing console (pre-power amp). If it is lit constantly, this indicates that the effects processor is overdriven, which can lead to unpleasant distortion. CONTROL ELEMENTS 5 EUROPOWER PMP2000 2. 2 Rear panel The mains connection is on a standard IEC receptacle. Before connecting the unit to the mains, ensure that the voltage setting matches your local voltage. Blown fuses should only be replaced by fuses of the same type and rating. The POWER switch should always be in the "Off" position when you are about to connect your unit to the mains. Attention: The POWER switch does not fully disconnect the unit from the mains. Unplug the power cord completely when the unit is not used for prolonged periods of time. This is the RIGHT/MONO MAIN loudspeaker output of your PMP2000, where you can connect the right loudspeaker of a stereo system. If, however, you run a mono main mix (switch set to its lower position), this loudspeaker output provides the main mix signal in mono. The impedance of the loudspeaker connected here must not fall below 4 . The BRIDGE loudspeaker output allows you to combine the left and right stereo channel in one mono output, which is useful for applications that require the use of one loudspeaker only. To use the BRIDGE output, switch must be set to "LEFT/RIGHT". Always connect the BRIDGE jack to a loudspeaker with a minimum impedance of 8 !Please note that the power delivered to the speaker connected to the BRIDGE output is considerably higher than the power provided to the speakers wired to the parallel speaker outputs. When using the BRIDGE loudspeaker output, NEVER use any of the other two connectors (RIGHT/MONO MAIN and LEFT/MONITOR) at the same time!This is the LEFT/MONITOR loudspeaker output of your PMP2000, to which you can connect the left loudspeaker of a stereo system (switch set to its upper position). If you do a main mix in mono (switch set to its lower position), this loudspeaker output provides the monitor signal in mono. [. . . ] Damages/defects caused by the following conditions are not covered by this warranty: improper handling, neglect or failure to operate the unit in compliance with the instructions given in BEHRINGER user or service manuals. connection or operation of the unit in any way that does not comply with the technical or safety regulations applicable in the country where the product is used. damages/defects caused by force majeure or any other condition that is beyond the control of BEHRINGER. Any repair or opening of the unit carried out by unauthorized personnel (user included) will void the warranty. [. . . ]