User manual BEHRINGER PMP1280S

[. . . ] PMP860M/PMP880S/PMP1280S User manual Version 1. 1 November 2006 EUROPOWER EUROPOWER PMP860M/PMP880S/PMP1280S IMPORTANT SAFETY INSTRUCTIONS 12) Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. 14) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain and moisture. [. . . ] So, disconnect the 2TR IN from the recorder, before you start recording!The MAIN " connectors allow you to send the main signal to an external amplifier, when you only wish to use the mixer and effects section. Connect your monitor power amps or active monitor speakers to the mono MONITOR output to monitor the signal mix created with the MON controls or to route it to the musicians on stage. The POWER switch should always be in the Off position when you are about to connect the unit to the mains. Please note: The POWER switch does not fully disconnect the unit from the mains. Unplug the power cord completely when the unit is not used for prolonged periods of time. + + In BRIDGE mode, always connect only one loudspeaker with an impedance of at least 8 W to OUTPUT B (pins 1+/2+)!Please note that OUTPUT A must NEVER be used in BRIDGE mode (with pin connections 1+/2+)!In all other operating modes, the minimum impedance of the speaker connected must not fall below 4 W. Use the SPEAKER PROCESSING switch to activate a filter that adapts the mixer to the specifications of your loudspeakers. If the speakers have a limited frequency response in the bass range, it allows you to adapt it optimally to the frequency response of the speakers. During breaks you can thus prevent the microphones from picking up noise or interference, which would then be reproduced by the P. A. The advantage is that all faders can be left untouched while you play a CD via the CD/TAPE inputs (see ). There is also no need to move down the faders of muted channels and lose your mix. + + 2. 4 Rear panel The mains connection is on a standard IEC receptacle. Before connecting the unit to the mains, ensure that the voltage setting matches your local voltage. Blown fuses should only be replaced by fuses of the same type and rating. PMP880S/PMP1280S: Depending on the operating mode selected (see ) either the left main signal or the monitor signal is provided at OUTPUT A. PMP860M: In MON/MAIN mode, the monitor signal is provided at OUTPUT A (see ). NEVER use this output in bridged mono mode, except when you use a cable with the normal pin connections (pins 1+/1-). In this case you can take the mono main signal from this output in MAIN/MAIN (BRIDGE) mode (not bridged). Please note that the power delivered to the speaker in bridged mono mode is considerably higher than in other operating modes. Please read the information given on the rear panel of the power mixer. PMP880S/PMP1280S: Depending on the operating mode selected (see ) either the right main signal, the mono main signal or the bridged mono signal is provided at OUTPUT B. [. . . ] Any repair or opening of the unit carried out by unauthorized personnel (user included) will void the warranty. If an inspection of the product by BEHRINGER shows that the defect in question is not covered by the warranty, the inspection costs are payable by the customer. Products which do not meet the terms of this warranty will be repaired exclusively at the buyers expense. If the buyer fails to submit a written repair order within 6 weeks after notification, BEHRINGER will return the unit C. O. D. [. . . ]