User manual BEHRINGER PMH660M

[. . . ] PMH660M/PMH880S Users Manual Version 1. 4 August 2006 EUROPOWER EUROPOWER PMH660M/PMH880S IMPORTANT SAFETY INSTRUCTIONS DETAILED SAFETY INSTRUCTIONS: 1) Read these instructions. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] NEVER use this output in bridged mono mode, except when you use a cable with the normal pin connections (SPEAKON cable: pins 1+/1-). In this case you can take the mono main signal from this output in MAIN/MAIN (BRIDGE) mode (not bridged). Please note that the power delivered to the speaker in bridged mono mode is considerably higher than in other operating modes. Please read the information given on the rear panel of the power mixer. PMH880S: Depending on the operating mode selected (see ) either the right main signal, the mono main signal or the bridged mono signal is provided at OUTPUT B. 2. 3. 1 Connectors The FOOTSWITCH connector is for a standard footswitch. Please use a dual footswitch for the PMH880S, so that you can enable/disable FX1 and FX2 independently of each other. In this case, the tip of the 1/4" plug controls FX1, and the ring FX2. The FX OUT connector is used to route the FX SEND signal from the input channels, for example, to the input of an external effects processor. The PMH880S has two FX controls per input signal (see ) and also two FX OUT connectors (FX OUT 1 and FX OUT 2). Please note: When you connect a mono plug to one of the FX OUT jacks, the signal path from the respective FX send to the built-in effects processor is interrupted. For each FX send you can either use the built-in effect or the corresponding FX OUT jack (for an external effect), but never both at the same time. When you use a stereo plug (tip and ring interconnected) you can use the built-in effects processor and the FX OUT jacks in parallel. Use the AUX IN 1/4" inputs to route an external stereo signal to the main mix. Use the left input for mono signals, which are then reproduced on both stereo sides. The AUX IN control adjusts the volume of the external signal in the main mix. The 2TR IN RCA input allows you to feed in external stereo signals, e. g. from a CD player, tape deck or other line-level source. + + + 6 2. CONTROL ELEMENTS EUROPOWER PMH660M/PMH880S PMH660M: Either the main or the bridged main mono signal ). When you use a cable is provided at OUTPUT B (see with the normal pin connections (SPEAKON cable: pins 1+/1-), it is possible in MAIN/MAIN (BRIDGE) mode to take the mono main signal from this output (not bridged). A very pleasant detune effect is created in connection with the pitch variation. The chorus effect is used often and quite extensively used for dispersing signals. SYMPHONIC: This effect creates the sound of an eight-voice (!) vocal chorus. [. . . ] Any product deemed eligible for repair or replacement under the terms of this warranty will be repaired or replaced. If the product needs to be modified or adapted in order to comply with applicable technical or safety standards on a national or local level, in any country which is not the country for which the product was originally developed and manufactured, this modification/adaptation shall not be considered a defect in materials or workmanship. The warranty does not cover any such modification/adaptation, irrespective of whether it was carried out properly or not. Under the terms of this warranty, BEHRINGER shall not be held responsible for any cost resulting from such a modification/adaptation. [. . . ]