User manual BEHRINGER PMH3000

[. . . ] EUROPOWER PMH1000/PMH3000/PMH5000 ENGLISH User's Manual Version 1. 2 November 2004 EUROPOWER PMH1000/PMH3000/PMH5000 IMPORTANT SAFETY INSTRUCTIONS DETAILED SAFETY INSTRUCTIONS: 1) Read these instructions. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the polarized or grounding-type plug. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] Pressing the AFL switch (after-fader listening) activates the solo function. If AFL is on for the corresponding channel in the main section, you will only hear the signal from this channel. Switching AFL on has no effect on the main or monitor mix, as long as you don't move the fader. In this way, you can monitor one or several selected signals via the PHONES/ CTRL jack . This is the master send fader for the signal routed to the effects processor and to the FX SEND output (see also and ). 6 2. CONTROL ELEMENTS EUROPOWER PMH1000/PMH3000/PMH5000 PMH1000: MON SEND fader. These faders are used to set the monitor output volume (see also and ). PMH1000: The main mix allows you to control the volume from the Main 1 output with both faders. PMH3000/PMH5000: The MAIN 1 fader controls the volume of the EUROPOWER. PMH3000/PMH5000: The MONO fader controls the mono mix signal (see also ). PMH5000: The SUB FILTER filters out frequencies above the selected setting, so that only low frequencies are sent to an (active) subwoofer via the MONO OUT ). PMH5000: The SUB FREQ control determines the cut-off frequency for the subwoofer output. The PHONS/CTRL R control adjusts the headphone or control room volume (see also ). PMH3000/PMH5000: The MAIN 2 control determines the volume at the MAIN 2 output (see also ), which is the same signal as at MAIN 1, but with extra output jacks and separate volume control. PMH3000/PMH5000: With the CD/TAPE IN control you can adjust the volume of the line signal present at the CD/TAPE INPUT . PMH1000: With the CD/TAPE RET fader you can adjust the line signal applied to the CD/TAPE INPUT . The FX SEND connector can be used to route the FX SEND signal from the input channel, for example, to the input of an external effects device. Since the PMH5000 has two FX controls per input signal (see ), both FX SEND 1+2 are present at one jack. Please note: The SEND signal is in parallel with the FX SEND jacks and with the effects processor, so that both can be controlled together by one control. For the FX signals, use a 1/4" stereo plug connected as follows: FX1 = tip; FX2 = ring The PHONS/CTRL connector allows you to connect a pair of stereo headphones or an (active) monitor speaker. 2. 5 Rear panel The mains connection is via a standard IEC receptacle. Before connecting the unit to the mains, ensure that the voltage setting matches your local voltage. Blown fuses should only be replaced by fuses of the same type and rating. [. . . ] The warranty does not cover any such modification/adaptation, irrespective of whether it was carried out properly or not. Under the terms of this warranty, BEHRINGER shall not be held responsible for any cost resulting from such a modification/adaptation. Free inspections and maintenance/repair work are expressly excluded from this warranty, in particular, if caused by improper handling of the product by the user. This also applies to defects caused by normal wear and tear, in particular, of faders, crossfaders, potentiometers, keys/buttons, tubes, guitar strings, illuminants and similar parts. [. . . ]