User manual BEHRINGER LC2412

[. . . ] LC2412 Users Manual Version 1. 1 May 2004 EUROLIGHT ENGLISH EUROLIGHT LC2412 IMPORTANT SAFETY INSTRUCTIONS DETAILED SAFETY INSTRUCTIONS: 1) Read these instructions. CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] 4. 2). 4. 1 Programming, recalling and altering memories (scenes) 4. 1. 1 Programming 1. Set up a stage design (scene) while in preset mode (Fader A PRESET section). 4. 2: Display Editing memory in preview mode You can implement the desired changes now by using the faders of the A PRESET section. To change the programmed settings of preset faders, you must first draw the fader to its original position. The channels not activated during the previous programming can be raised as usual. Either confirm the next memory or quit the preview mode by hitting the QUIT key . Otherwise, you can also program the memory anew, as described at the beginning of this chapter. Fig. 4. 1: Display Program memory The meaning behind the above line: the next step (select memory), location (memory slot number/storage bank). You have already selected a storage bank using the UP/DOWN keys (7), and now use the FLASH keys to select a location. Lower line: Make a selection by pressing SOFT A (preset) or SOFT B (all). If you also want to store an active memory along with the adjusted preset, then press SOFT B . This way, you have the option to generate several variations out of a single memory. How memories are modified is explained in chapter 4. 1. 3. 4. 2 Crossfading between different setups 4. 2. 1 Crossfading between presets and memories Crossfading between memories and presets works exactly the same way as crossfading between two presets. The only difference is that the EUROLIGHT LC2412 has to be in memory mode. Activate a preset by using a fader from the A PRESET section; fader A remains locked. + Should you wish to store additional presets, simply repeat the steps: 1. The preset appears at the console output, while the memories dissappear. 4. 2. 2 Crossfading between memories There are several ways to crossfade between memories: Crossfading steplessly using the FLASH keys Please take the following required steps, as follows: 1. ; ; previously remains on the stage unti you pull the fader to zero. The LEDs of the UP/DOWN keys flash in case there are active memories belonging to the abandoned bank. Pull up a memory fader, and the memory stored at this location in the new storage bank is activated. + The memories that were activated before you changed the bank remain visible on the stage until you pull the fader down into its zero position. This way, you can see multiple memories on the stage (and the respective control lights). 4. Adjust the X-FADE control speed; 4. 3 Preset flash and memory flash 4. 3. 1 Preset flash This key activates the flash function for the A PRESET section. If the solo function is not active, PRESET FLASH adds a lighting configuration (set up in the A PRESET section) to an active memory (fader A at zero). [. . . ] Under the terms of this warranty, BEHRINGER shall not be held responsible for any cost resulting from such a modification/adaptation. Free inspections and maintenance/repair work are expressly excluded from this warranty, in particular, if caused by improper handling of the product by the user. This also applies to defects caused by normal wear and tear, in particular, of faders, crossfaders, potentiometers, keys/buttons, tubes and similar parts. Damages/defects caused by the following conditions are not covered by this warranty: s improper handling, neglect or failure to operate the unit in compliance with the instructions given in BEHRINGER user or service manuals. [. . . ]