User manual BEHRINGER CX2310

[. . . ] CX2310 Users Manual Version 1. 0 March 2001 SUPER-X PRO ® www. behringer. com ENGLISH SUPER-X PRO CX2310 SAFETY INSTRUCTIONS CAUTION: To reduce the risk of electric shock, do not remove the cover (or back). No user serviceable parts inside; refer servicing to qualified personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous voltage inside the enclosurevoltage that may be sufficient to constitute a risk of shock. This symbol, wherever it appears, alerts you to important operating and maintenance instructions in the accompanying literature. [. . . ] CONTROL ELEMENTS 7 + 6 7 8 9 SUPER-X PRO CX2310 2. 2 Mono 3-way operation with separate subwoofer signal First activate mono 3-way mode using the MODE switch on the rear panel (switch released). They show which controls are active for the mode of operation, which you have selected. The text on the first label shows the functions of these controls. Fig. 2. 3: Active control elements on the front panel of the SUPER-X PRO in mono 3-way operation with separate subwoofer signal 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 INPUT control. This control governs the crossover frequency between the low and middle bands. This controls the output level of the low band over the range -6 to +6 dB. This control governs the crossover frequency between the mid and high bands. This is used to control the output level of the mid band over the range -6 to +6 dB. This controls the output level of the high band over the range from -6 to +6 dB. This control governs the crossover frequency between the low signal and the subwoofer signal. This switch is used to reverse the polarity of the subwoofer output signal. 2. 4: Active control elements and connections on the rear panel of the SUPER-X PRO in mono 3-way operation with separate subwoofer signal 1 2 3 4 5 6 7 HIGH OUTPUT connector. This is used to switch between the control ranges of the front panel MID/HIGH XOVER FREQ. This is used to switch between the control ranges of the front panel LOW/MID XOVER FREQ. Switching between these whilst the equipment is in use produces heavy interference noise which could damage the loudspeakers or the system. This signal remains constant in mono and stereo mode and offers an additional way of providing 2-way and 3-way operation (see chapter 3. 5). + 8 3. APPLICATIONS You will need some tools to help set up the SUPER-X PRO to its optimal configuration. To set up the crossover frequency you need to know which frequency range a loudspeaker stack covers, over which range the sound energy is linearly transmitted, and where reductions or increases in the frequency response occur. In addition, every room has different size and quality characteristics. These strongly influence the sound response, since resonances and reflections in the different frequency ranges can also lead to reductions or increases in the sound picture. You will need suitable equipment in order to be able to recognize and compensate for these features. 3. 1 Tools You will need a high-grade microphone for making measurements. This should have a frequency response that should be as linear as possible (e. g. [. . . ] Subsequently, the product must be returned in its original shipping carton, together with the return authorization number to the address indicated by BEHRINGER. Warranty services will be furnished only if the product is accompanied by a copy of the original retail dealers invoice. Any product deemed eligible for repair or replacement by BEHRINGER under the terms of this warranty will be repaired or replaced within 30 days of receipt of the product at BEHRINGER. If the product needs to be modified or adapted in order to comply with applicable technical or safety standards on a national or local level, in any country which is not the country for which the product was originally developed and manufactured, this modification/adaptation shall not be considered a defect in materials or workmanship. [. . . ]