User manual BEHRINGER CT100

[. . . ] CT100 Users Manual Version 1. 0 April 2001 CABLE TESTER www. behringer. com ENGLISH CABLE TESTER CT100 1. With the CT100, you have purchased an indispensable tool that enables you to easily check the most common cables used by musicians and sound engineers. [. . . ] Any change in wiring or break in the signal flow will cause the LED of the corresponding input pin to light up. The LED will stay lit until RESET is pressed again, assuring detection of even the shortest breaks in the signal flow. It is a good idea to repeat the test after resetting the LEDs to double-check the initial results. 2 CABLE TESTER CT100 3. INSTALLED CABLE TESTER MODE This mode enables you to test cables in fixed installations or situations that dont allow you to connect both ends of the cable to the CT100. + Hold down the RESET button while moving the ON switch to the CABLE TESTER position. The ON LED will blink to indicate that the CT100 is in INSTALLED CABLE TESTER MODE. To test a cable for short circuits, connect one end of the cable to the appropriate OUT jack of the CT100. If no LEDs light, the cable is free of short circuits. 3. 1 Continuity check in INSTALLED CABLE TESTER MODE For a continuity check, connect a shorting jack (a jack in which pins are short-circuited to one another) to the other end of the cable. If there are no breaks in the signal flow, the display will show the corresponding pins as being shorted to each other. If the display indicates no short circuit, there is a break in the signal flow. + + The testing of intermittent connections works exactly as in CABLE TESTER MODE (see chapter 2. 1). INSTALLED CABLE TESTER MODE will not indicate connections between out and in pins. TEST TONE MODE + + Move the ON switch to the position TEST TONE. Do not use the TEST TONE MODE for MIDI cables! 3 CABLE TESTER CT100 TEST TONE MODE may be used to check signal flow and to facilitate level adjustments. Use the TEST TONE LEVEL switch to choose between +4 dBu, -10 dBV, or -50 dBV mic level. [. . . ] MULTILINGUAL DOCUMENTATION + The following versions of this users manual can be downloaded free of charge at http://www. behringer. com: German, French, Spanish, Italian, Dutch, Finnish, Swedish, Danish, Portuguese and Greek. 5 CABLE TESTER CT100 The information contained in this manual is subject to change without notice. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording of any kind, for any purpose, without the express written permission of BEHRINGER Spezielle Studiotechnik GmbH. [. . . ]