User manual BEGLEC Z-3000II

[. . . ] Please follow these operation, safety and maintenance instructions to ensure a long and safe life for your fog machine. Congratulations on the purchase of your new ANTARI Z-Series II FOG MACHINE. Disconnect the appliance from the electric supply before refilling liquid, cleaning or performing maintenance on the machine. Always unplug your ANTARI Z-Series II Fog Machine before filling its tank. [. . . ] If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the external fuse, remote control connection and power from the wall. If fog does not come out after holding the remote button down for 30 seconds, check the hose attached to the tank to make sure there is fluid going through the hose. If you are unable to determine the cause of the problem, do not simply continue pushing the remote button, as this may damage the unit. Operating this unit without liquid will cause damage to the pump as well as over-heating of the heater. If your ANTARI Z-1500II or Z-3000II Fog Machine fails to work properly, discontinue use immediately. Drain all fog liquid from the tank, pack the unit securely (preferably in the original packing material), and return it to your ANTARI dealer for service. If fog liquid comes in contact with skin or eyes, rinse thoroughly with water. Note: Pay attention to all warning labels and instructions printed on the exterior of your ANTARI Fog Machine Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact. One unit of One unit of Z-Series II Fog Machine Power cord Z-20 multi-function remote control with attached cord User Manual If any equipment is missing contact your ANTARI dealer immediately. Before beginning your initial setup on ANTARI Z-1500II or Z-3000II Fog Machine, make sure that there is no evident damage caused by transportation. In the event that the unit's housing or cable is damaged, do not plug it in and do not attempt to use it until after contacting your ANTARI dealer for assistance. Fill with ANTARI fog liquid or other high-quality water-based fog fluid recommended by ANTARI dealer. Any other types of fluid can damage the unit resulting in spitting and serious clogging problem. Its LCD displays current operating parameters, which are automatically stored in non-volatile memory, allowing the machine to be powered down without losing function settings. The Plug should be in a position that is accessible when using the machine. Warm-up is completed when the display on the control module shows "Ready to Fog" The control unit display will display "Warming up" and "Ready to fog" as the machine re-heats to the proper Do not allow the fog liquid to become contaminated. Always replace the caps on the fog liquid container and the fog machine liquid tank immediately after filling. After every 40 hours of continuous operation, it is recommended to run a cleaning solution composed of 80% distilled water and 20% white vinegar through the system to prevent the accumulation of particulate matter in the heating element. Run the machine briefly to clear any cleaning solution from the pump and heater. [. . . ] All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so after All fog machines have a recycling period after long bursts when the machine will shut itself down for a short Period in order to heat up again. DMX Setting for Z-1500II & Z-3000II fog machines with on board DMX Channel A These two models use 1 channel to control volume output operation. Timer functions such as duration and interval can be programmed using the DMX controller or the DMX control software being used by lighting and effects operator. With 6 being the minimum volume of fog produced and 249 approaching the maximum. [. . . ]