User manual BEGLEC Z-1000II

[. . . ] If the supply cord is damaged, it must be replaced by manufacturer or its service agent or similarly qualified The output nozzle becomes very hot during operation (300°C). Keep flammable materials at least 50 cm Always allow your ANTARI Fog Machine to cool down before attempting to clean or service it. Danger of Explosion Never add flammable liquids of any kind (such as oil, gas, perfume) to the fog liquid. Use only high-quality, water-based fog liquid that your dealer recommends. [. . . ] If moisture, water, or fog fluid gets inside the housing, immediately unplug the unit and contact a service technician or your ANTARI dealer before using it again. Any other types of fluid can Damage the unit resulting in spitting and serious clogging problem. Firmly attach the remote control cable to the proper input on the back of the machine. Danger of Burns For adult use only and must be installed out of the reach of children. Never leave the unit running Avoid coming within 60 cm of the output nozzle during operation. In order to guarantee adequate ventilation, allow a free air space of at least 20 cm around the sides and top of the unit. Turn the power switch to "ON" on the back of the The unit will take a couple of minutes to warm up the heater. When the remote control is attached the red lights (on Z-800II handle) and green light (on the remote) will flash and stay ON when the warm-up time is complete. For further information on operating your ANTARI Z-800II, Z-1000II and Z-1020 Fog Machine, see the section titled "Remote Control Operation". Because this may result in some Important: Always monitor tank fluid level as you are fogging. If your model includes a mounting bracket designed for overhead installation, it may be installed at floor level or suspended overhead. If the unit is to be mounted using the bracket, it is important that the fog does not shoot directly at any one's face. Whatever installation method you choose, do not allow the unit to have more than a 15 degree angle of inclination. If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the external fuse, remote control connection and power from the wall. If fog does not come out after holding the remote button down for 30 seconds, check the hose attached to the tank to make sure there is fluid going through the hose. If you are unable to determine the cause of the problem, do not simply continue pushing the remote button, as this may damage the unit. Moisture accumulation on the surface below the output nozzle, consider this condensation when installing your unit. All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so after being turned off. All fog machines have a recycling period after long bursts when the machine will shut itself down for a short period in order to heat up again. [. . . ] When pressed, the green MANUAL button overrides all other functions controls, and activates maximum output. DMX Setting for Z-1000II and Z-1020 fog machines with on board DMX Channel A Einleitung These two models use 1 channel to control on/off operation. On/Off function can be programmed using the DMX controller or the DMX control software being used by lighting and effects operator. between the values 129 to 255 the volume of fog output is is at maximum. [. . . ]