User manual BEGLEC WORLD STAR COLOR BALL

[. . . ] The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Check the contents: Check that the carton contains the following items: Worldstar or Colorball unit Operating instructions EHJ 250W 24V lamp Don't place metal objects or spill liquid inside the unit. If a foreign object enters the unit, immediately disconnect the mains power. Locate the fixture in a well ventilated spot, away from any flammable materials and/or liquids. [. . . ] CAUTION: To reduce the risk of electric shock, do not remove the top cover. FIXING HOLES DOME: The dome starts turning once the power cable is connected to the mains. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. The minimum distance between lightoutput and the illuminated surface must be more than 1 meters. To protect the environment, please try to recycle the packing material as much as possible. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. In case of replacement of the lamp or maintenance, do not open the fixture within 15 minutes until the unit cools down after switching off. Unplug the mains cable to switch off the unit Wait for about 15 minutes until the unit has been cooled down. ( A on the drawing ) On the inside of the dome you will see the lamp socket Unplug the old lamp. Hold the lamp socket while unplugging the lamp Hold the lamp socket while pressing the new lamp gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Lamps with higher wattage generate temperatures the device was not designed for. if the device uses a lamp transformer , it will burn due to current overload. If you touched the lamp, clean it with a cloth and a little denatured alcohol. Make sure the area below the installation place is free from unwanted persons during servicing. Switch off the unit, unplug the mains cable and wait until the unit has been cooled down. Duringinspection the following points should be checked: All screws used for installing the device and any of its parts should be tightly fastened and may not be corroded. Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. [. . . ] Don't cover any ventilation openings as this may result in overheating. The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. Every information is subject to change without prior notice You can download the latest version of this user manual on our website: www. [. . . ]