User manual BEGLEC USB 900 V 1.0

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. To take full advantage of all possibilities, please read these operating instructions very carefully. Before you start using this unit, please check if there's no transportation damage. [. . . ] Note that, due to the high output power, you can permanently damage your ears!USB-B slot: The USB900 has two USB-slots (2 slot is located on the front (15), named "USB-A"). You can connect any USB-based mass storage device like USB-sticks and small, portable hard disks. Even some portable phones with built-in MP3 function can be connected however this doesn't work always. (to be tested by the user) See "Source Select" button n°16 description for more information on how to select the desired memory device. PS: although the USB slots can deliver the 5Vdc needed for portable hard disks, we recommend using a hard disk with separate power supply input. AUDIO OUTPUT from right player: Output for the audio signal from the right player. Use the supplied cinch/cinch cables to connect these outputs to the CD/line input of an external mixing unit. AUDIO OUTPUT from left player or mixer: Output depends on the MIXER MODE you selected in the setup menu (see chapter SETUP MENU for more information): MIXER MODE = Ext -Tone: output for the audio signal from the left player. Use the supplied cinch/cinch cables to connect these outputs to the CD/line input of an external mixing unit. MIXER MODE = Ext +Tone: same as "Ext ­Tone" but now the tone controls can be used. Use the supplied cinch/cinch cables to connect this output to the input of an amplifier or powered speaker cabinets. FADER START Sockets: If you are using a mixer with fader start function, connect the player with the fader start of the mixer. Please note that these sockets must never be connected with any voltage. Attention: This remote control is only compatible with certain (Synq® or Pioneer® compatible) mixers. PITCH DISPLAY: Shows the actual percentage of speed change, selected with the SPEED slider. The small padlock is shown when the pitch lock function (Master Tempo) is active. (see chapter SETUP MENU for more information) Note: for MP3 files it's not possible to show the total remaining time for all tracks on the memory device. SINGLE: appears when the unit is set to play just one track at a time. When it is not shown, the player plays continuously through all tracks. In the setup menu you can adapt several parameters of the USB900 to your personal taste. to access the setup menu , just press the SEARCH button (3) for about 1. [. . . ] RECALLING "HOT CUE POINTS/LOOPS" FROM PERMANENT MEMORY: In the SETUP menu you can determine how you want the cue points to be loaded. DIFFERENT MEMORIES: Before we talk about using the memory, we have to know the difference between "track memory" and "permanent memory": Track Memory: This is the memory where the USB900 stores a set of up to four cue points and/or loops for one track. You can set up a "track memory" for every single track on the memory device. Example: your memory device contains 800 tracks for every track you can store up to 4 cue points and/or loops. [. . . ]