User manual BEGLEC TWINBEAM COLOR LASER VERSION 1.1

[. . . ] It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Check the contents: Check that the carton contains the following items: TWINBEAM COLOR Laser unit 2 keys (for key switch) Mains cable Operating instructions CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. [. . . ] This product is a so-called show laser, emitting radiation with a wavelength spectrum between 400 and 700 nm and producing lighting effects for shows. Due to the construction of this laser, the beam is moved so fast, that it can only hit the eye very short. This is why the use of this laser for a Laser-Light-Show can be regarded as save. Never direct the laser beam to people or animals and never leave this device running unattended. The operation of a class 3B show laser is only allowed if the operation is controlled by a skilled and well-trained operator. Depending on the classification, operating a laser product can produce laser radiation that may cause permanent eye damage and/or skin damage. The legal instructions for using a laser product vary from country to country. The user must always inform himself on the legal instructions valid in his country and apply them to his situation. Please note that JB SYSTEMS cannot be made liable for damages caused by incorrect installations and unskilled operation!DMX OUTPUT: 3pin female XLR-connector used to connect the Twinbeam laser with the next unit in the DMX chain. DIP-SWITCHES: switches 1~8 are used to set the DMX address between 000 and 255. Switch 9 is not used and switch 10 is used to select stand-alone or DMX mode. AUTO/MUSIC SWITCH: when the unit is used in stand-alone mode, this switch sets the laser in music mode (patterns move to the rhythm of the beat) or auto mode (patterns move automatically) 10. SAFETY EYE: used to attach a safety cable when the unit is rigged (see paragraph "overhead rigging" 11. MUSIC INPUT SENSITIVITY: This potentiometer is used to adjust the music input sensitivity. SOUND LED: flashes to the sound of the music detected by the internal microphone. HANGING BRACKET: with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. LASER OUTPUT: Here the laser beam leaves the enclosure, make sure to NEVER look inside the unit through this opening while the laser effect is switched on!LASER WARNING SIGN: warns against a potentially dangerous laser when not used by skilled operators. MAINS INPUT: with IEC socket and integrated fuse holder and power switch, connect the supplied mains cable here. Use the keys to make sure only a skilled operator is able to switch the laser on. INTERLOCK input: used to connect the optional emergency stop switch (see picture). [. . . ] Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly. [. . . ]