User manual BEGLEC TUBELED CONTROLLER V1.1

[. . . ] This manual only explains installation of the tubes, refer to the controller user manual to know everything about how to use the TUBELEDTM system. Suitable for outdoor use due to IP44 protection grade Up to 4000 tubes can be connected to the controller (not included) Direct mains input, no costly extra power supplies needed!Extended life span: 50000 ­ 100000hours Low power consumption (P<12W) Solid aluminum holders for wall fixing included Perfect for use in: retail stores, commercial displays, architectural lighting, indoor and outdoor decoration, clubs, pubs, mobile DJs, trussing, . To protect the environment, try to recycle the packing material as much as possible. [. . . ] This fixture must be earthed to in order comply with safety regulations. Always use an appropriate and certified safety cable when installing the unit. Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the fixture and contact your dealer immediately. The housing and the lenses must be replaced if they are visibly damaged. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Don't use the effect in the presence of persons suffering from epilepsy. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, derigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered! [. . . ] GROUND CONNECTION: Use this connection to ground the led tubes properly. Every information is subject to change without prior notice You can download the latest version of this user manual on our website: www. Test each tube independently before installing: just connect each tube separately to the mains voltage (no signal cables connected!The tubes are suitable for outdoor applications; however they may NOT be used under water! [. . . ]