User manual BEGLEC THUNDERBIRD X VERSION 1.0

[. . . ] â· Keep this booklet in a safe place for future consultation. â· Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. â· Allow the device about 10 minutes to cool down before replacing the bulb or start servicing. â· Always unplug the unit when it is not used for a longer time or before replacing the bulb or start servicing. [. . . ] â· To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. â· Don't place metal objects or spill liquid inside the unit. If a foreign object enters the unit, immediately disconnect the mains power. â· Locate the fixture in a well ventilated spot, away from any flammable materials and/or liquids. â· Don't cover any ventilation openings as this may result in overheating. â· Prevent use in dusty environments and clean the unit regularly. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. Use a screwdriver to unscrew the screws that close the lamp compartment of the fixture. Hold the lamp socket while pressing the new lamp gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Lamps with higher wattage generate temperatures the device was not designed for. if the device uses a lamp transformer , it will burn due to current overload. If you touched the lamp, clean it with a cloth and a little denatured alcohol. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. â· Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. â· Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. â· The device should be installed out of reach of people and outside areas where persons may walk by or be seated. â· Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. [. . . ] â· Clean with a soft cloth using normal glass cleaning products. â· Clean the external optics at least once every 30 days. Mains Input: Fuse: Sound Control: Lamp: Size: Weight: AC 230V, 50Hz 250V 3, 15A slow blow (20mm glass) Internal microphone FCR 100W / 12V 28 x 23 x 13cm 5kg Every information is subject to change without prior notice Once connected to the mains the device starts running. â· Regular breaks during operation are essential to maximize the life of this device as it is not designed for continual use. [. . . ]