User manual BEGLEC THEATRE SPOT 500W V 1.1

[. . . ] It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. [. . . ] In the event of serious operating problems, stop using the fixture and contact your dealer immediately. The housing and the lenses must be replaced if they are visibly damaged. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Don't use the effect in the presence of persons suffering from epilepsy. Handle Hanging bracket Filter frame Barn door support Knob to open the lamp compartment Mains cable fixing point for safety cable Screw for focusing system This symbol means: indoor use only. The minimum distance between light-output and the illuminated surface must be more than 1 m for the 500W version and more than 2m for the 1000W version. To protect the environment, please try to recycle the packing material as much as possible. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. Hold the lamp socket while pressing the new lamp gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Lamps with higher wattage generate temperatures the device was not designed for. If you touched the lamp, clean it with a cloth and a little denatured alcohol. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. [. . . ] During inspection the following points should be checked: All screws used for installing the device and any of its parts should be tightly fastened and may not be corroded. Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. [. . . ]