User manual BEGLEC T3 V 1.2

[. . . ] minimum distances around the apparatus for sufficient ventilation is 5cm. Always unplug the unit when it is not used for a longer time or before you start servicing. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. [. . . ] Because of its two start/stop buttons the T3 turntable can be used in both traditional and battle style setups: CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. Battle style setup: Mostly used for scratching and other aggressive mixing techniques This symbol means: indoor use only. This symbol means: Safety Class II appliance To prevent fire or shock hazard, do not expose this appliance to rain or moisture. CLEANING THE TURNTABLE: Clean by wiping with a cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. This makes it easier to manipulate the record for scratch performances. MOTOR OFF BUTTON: Normally the platter stops while you press the start/stop button (1). In this case the platter stops quite fast due to the electronic brake. Press the "motor off" button if you want the platter to slow down more smoothly. as long as the motor is switched off , the led of the button flashes. TARGET LIGHT: White led target light used to locate the exact place on your record when used in a dark place. REVERSE BUTTON: Press this button to reverse the platter rotation, press this button again to end the reverse mode. The next time you press this button you will switch again to +/-8% etc. QUARTZ LOCK BUTTON: When the QUARTZ Button is pressed, the exact center speed (0%) is enforced, even when the pitch slider is not in the middle. When the slider is in its middle position, the blue led next to the pitch slider will turn on to indicate that the turntable is locked to the exact center speed. SINGLE ADAPTER: Place this adapter on the platter for playing 7" records with large center holes. POWER CORD CONNECTOR: Used to connect to the mains, using the supplied power cord. PHONO/LINE SWITCH: Depending on the position of the phono/line switch, you can connect the turntable to any phono or line level input. [. . . ] You can use the anti-skate knob to offset this force and keep the needle centered in the groove. For standard playback simply turn the anti-skate knob to the same number as the stylus pressure reads in grams. TONE ARM CLAMP & REST: Use this rest for the tone arm while changing a record. Attach the tone arm to the rest using the clamp when the turntable is not used or when it is transported. [. . . ]