User manual BEGLEC SIRIUS V1.0

[. . . ] n'exposez jamais la lentille directement aux rayons de soleil, même pendant un bref instant. Ceci peut endommager l'intérieur de l'appareil ou même causer un incendie !stel de lens nooit bloot aan direct zonlicht, zelfs gedurende een korte periode. Setzen sie die Linse niemals direkter Sonneneinstrahlung aus, auch nicht für eine kurze Zeit ! [. . . ] Once the required mode is selected, press the ENTER button to confirm. To go back to the main menu without any change press the MENU button shortly. Press the MENU button until "Addr" is shown on the display. Once the correct address shows on the display, press the ENTER button to save it. To go back to the main menu without any change press the MENU button shortly. If you want to go back to normal running mode: press the MENU button for about 2 seconds. Press the MENU button until "ChMd" is shown on the display. Once the desired channel setup mode shows on the display, press the ENTER button to save it. To go back to the main menu without any change press the MENU button shortly. If you want to go back to normal running mode: press the MENU button for about 2 seconds. HOW TO SET UP THE UNIT CONTROL PANEL: 1. LEDS DMX On DMX input present MASTER On Master mode SLAVE On Slave mode SOUND Flashing Sound activation Show Mode Used to choose the Show mode when used in standalone or master/slave mode. Press the MENU button until "ShMd" is showing on the display. Use DOWN and UP buttons to select one of the available shows: Show 1 (Sh 1): Fixture is placed on the floor. If you want to go back to normal running mode: press the MENU button for about 2 seconds. Sound State The unit works to rhythm of the beat when used in standalone or master/slave mode Press the MENU button until "SOUn" is shown on the display. Use DOWN and UP button to select "On" or "Off" mode. To go back to the main menu without any change press the MENU button shortly. If you want to go back to normal running mode: press the MENU button for about 2 seconds. Sound Sense Used to set the sensitivity of the internal microphone Press the MENU button until "SOSe" is shown on the display. Use DOWN and UP button to select a value between "0" (very low sensitivity) and "100" (high sensitivity). To go back to the main menu without any change press the MENU button shortly. If you want to go back to normal running mode: press the MENU button for about 2 seconds. [. . . ] Pin layout XLR-3pin: Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+) JB SYSTEM® 7/10 SIRIUS JB SYSTEM® 8/10 SIRIUS ENGLISH USER MANUAL ENGLISH USER MANUAL Pin layout XLR-5pin: Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+) ~ Pins4+5 not used. To prevent strange behavior of the light effects, due to interferences, you must use a 90 to 120 terminator at the end of the chain. Each light effect in the chain needs to have its proper starting address so it knows which commands from the controller it has to decode. In the next section you will learn how to set the DMX addresses. OPERATE THE UNIT BY CA8 OR RF8SET When used in standalone or master/slave mode we strongly advise you to use the CA-8 "Wired easy controller" or RF-8SET "Wireless easy controller". [. . . ]