User manual BEGLEC MIX 5.2 V1.0

[. . . ] No naked flame sources, such as lighted candles, should be placed on the appliance. Don't cover any ventilation openings as this may result in overheating. minimum distances around the apparatus for sufficient ventilation is 5cm. Always unplug the unit when it is not used for a longer time or before you start servicing. [. . . ] To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. CLEANING THE MIXER: Clean by wiping with a polished cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. Except for microphones, headphone and zone outputs, all connections are cinch. (example: JB Systems code: 2-0370) For more information on connections, please refer to the next chapter. Be sure to turn off the mixer before you make changes to the different connections. DJ MICRO input: The DJ micro can be connected to the XLR/Jack input on the front plate or to the stereo jack on rear panel. This input is balanced but accepts any kind of microphone equipped with an XLR or jack connector. TALKOVER level: When you switch the talkover(3) on, you can adjust the amount of muting on input channels 2 to 5. The more you turn to the right, the more these channels are muted while talking through the DJ Micro(1). TALKOVER switch: Use this switch to automatically mute the input channels 2 to 5 while you are talking through the DJ microphone. Use the zone selectors(4) to choose on which output the talkover should work. Attention: the talkover will only work on the zone you selected for the DJ Micro. ZONE switch: for every input channel you can choose to which zone (master) it should be routed. This means that you can use this mixer to serve two different rooms with completely different music!Now you can do announcements in both rooms, while the music you play in both rooms is completely different. INPUT SELECTOR switch: On channels 2 and 3 you can choose between line or balanced micro inputs. INPUT SELECTOR switch: On channels 4 and 5 you can choose between line or balanced micro inputs but you can also connect a turntable. BALANCE: used to adjust the balance between left and right output on Master A. VU-meters: Used to monitor the level of the audio signals selected with the CUE selector(13). With the channel faders you can change the input level of each connected audio source. [. . . ] Note: Feedback is where an acoustic signal is amplified over and over again until it develops rapidly into a loud screech: Reduce the gain on your microphone channel and/or try cutting HF from your tone controls. Power Supply: Fuse: Frequency response: THD + noise: S/N Ratio (IHF-A): Micro inputs: Line/CD inputs: Phono inputs: Record output: Master A/B output: Master A/B output: Talkover: Tone controls: Headphone: Dimensions: Weight: AC 230 V, 50Hz 20mm glass fuse 250V 500mA slow 20-20. LINE input: Used to connect any line level sound source to this channel. RECORD BUS A: line level output with the signals from channels 2 to 5. [. . . ]