User manual BEGLEC MIX 2 V 1.0

[. . . ] To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. No objects filled with liquids, such as vases, shall be placed on this appliance. If a foreign object enters the unit, immediately disconnect the mains power. [. . . ] In the event of serious operating problems, stop using the appliance and contact your dealer immediately. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. INSTALLATION GUIDELINES: Install the unit in a well-ventilated location where it will not be exposed to high temperatures or humidity. Placing and using the unit for long periods near heat-generating sources such as amplifiers, spotlights, etc. When installed in a booth or flight case, please make sure to have good ventilation to improve heat evacuation of the unit. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance. CLEANING THE APPLIANCE: Clean by wiping with a polished cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. This symbol means: indoor use only This symbol means: Read instructions This symbol means: Safety Class II appliance To prevent fire or shock hazard, do not expose this appliance to rain or moisture. (example: JB Systems code: 2-0370) For more information on connections, please refer to the next chapter. Be sure to turn off the mixer before you make changes to the different connections. FADER CONTROL: When connected to these inputs, compatible CD-players can be controlled by the fader starts of this mixer. POWER CONNECTOR: Plug in power adapter here and check the voltage level to match your country's standard. PHONO/LINE SWITCH: This switch makes it possible to switch between the Line and Phono level for these inputs. PHONO / LINE INPUTS: each used to connect two different audio signal levels. LINE INPUTS: Unbalanced RCA jacks for connecting stereo audio from line level sources such as CD players, Hi-fi VCR's, cassette and reel-to-reel tape decks, DAT machines, tuners, even synthesizers or other mixing consoles. [. . . ] The other CD-player starts playing from its previously programmed cue point. CROSSFADER IN RIGHT POSITION: CD-player connected to fader start connector B is playing, the other CD-player is paused. CROSSFADER MOVES TO THE LEFT: CD-player connected to fader start connector B stops playing, returns to its previously programmed cue point and waits in pause. The other CD-player starts playing from its previously programmed cue point. [. . . ]