User manual BEGLEC LED CROSSFIRE V1.0

[. . . ] The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. This symbol means: indoor use only This symbol means: Read instructions To protect the environment, please try to recycle the packing material as much as possible. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. [. . . ] The installations should be inspected every year by a skilled person to be sure that safety is still optimal. Din-5pin input, used to connect an optional wireless receiver, named RF-8R. Slave LED: is lit when the unit is in slave mode Sound LED: blinks to the rhythm of the music while the unit is in audio mode DMX LED: is lit when the unit receives a DMX-signal Master LED: is lit when the unit is switched as master MENU button: used to select the different menu items DOWN button: to go back in the menu and to lower the values shown on the display. uP button: to go up in the menu and to increase the values shown on the display. MAIN MENU: To select any of the menu options, press the MENU button up to when the required one is shown on the display. once the required menu option is selected , press the ENTER button to select. To go back to the functions without any change press the MENU button during 2 seconds or just wait 10 seconds. Once the correct address shows on the display, press the ENTER button to save it. Mains output with IEC socket: you can use a special IEC power cable to connect this output with the mains input of the next unit for easier linking. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. Safety eye, used to attach a safety cable when the unit is rigged, see paragraph "overhead rigging" 5. DMX output: 3pin female XLR-connector used to connect the effect with the next unit in the DMX chain. Press the ENTER button, the current working mode starts blinking in the display Use the DOWN and UP buttons to select (slave in sync with the master) or slave in anti-sync with the master). Blackout Mode Blackout mode: when no DMX-signal is detected, the unit goes in blackout. No blackout mode: when no DMX-signal is detected, the unit automatically switches to master mode. Use DOWN and UP buttons to select (display always on) or Once the mode is selected, press the ENTER button to save it. Show Mode Used to choose to select one of the preprogrammed shows when used in standalone or master/slave mode. Use DOWN and UP buttons to select one of the preprogrammed shows (random show), or (show 1) to (show 12) Once the right show blinks on the display, press the ENTER button to save it. Color mode If you like you can set the effect to just one of the 15 fixed colors. If you want to return to the built-in shows, just select Show mode and choose a show. Use DOWN and UP buttons to select one of the preprogrammed colors Col1 (color 1) to Co15 (color 15) Once the right color blinks on the display, press the ENTER button to save it. Sound Mode Used to choose the desired sound/manual mode to trigger the shows. [. . . ] During inspection the following points should be checked: All screws used for installing the device and any of its parts should be tightly fastened and may not be corroded. Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. [. . . ]