User manual BEGLEC LD-POWER 120 V1.0

[. . . ] No naked flame sources, such as lighted candles, should be placed on the appliance. Don't cover any ventilation openings as this may result in overheating. Always unplug the unit when it is not used for a longer time or before you start servicing. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. [. . . ] Two different splitters are available: o LD-SPLIT RJ45: used for normal indoor applications (ex. lD-BAR) o LD-SPLIT IP68: used for waterproof outdoor applications (ex. LD-AQUA, LD-UPLIGHT) TYPE 2: these LED-projectors always have two female RJ45 connectors (in/out). You can simply daisychain these projectors with standard patch cables. MASTER LED: is lit when no cable is connected to the DMX-input, the unit works in master mode and shows the last selected internal show. SLAVE LED: is lit when the DMX input is connected to another LDPOWER60/120 that works in master mode. POWER LED: is lit when the mains cable is inserted and the unit is working. Press this button for about 2seconds to leave the setup menu and save the selected options. DOWN BUTTON: press this button to go to the previous item in the setup menu or lower the value shown on the display. UP BUTTON: press this button to go to the next item in the setup menu or increase the value shown on the display. ENTER BUTTON: press this button to confirm your selection in the setup menu. Important: The installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. For example you can fix the unit against a wall using two adapted screws. The orientation is not important but make sure that enough ventilation is available. Make sure the unit is not connected to the mains during installation and wiring!The LD-POWER power supplies are intended only for use with passive LED projectors from our LD-series. the maximum cable length between the LD-POWER output and all connected projectors is 80meters!At the end of each line (zone) NO RJ45 connector can be left open, you MUST use a terminator (LD-TERM RJ-45) otherwise: NO light !2 different LED projectors exist: TYPE1 needs a splitter box to be connected, TYPE2 not!Electrical installation LED projector outputs: The passive LED projectors from our LD-series use CAT5e cables and RJ45 connectors to connect them to the LD-POWER power supplies. You can use our standard cables ("LD-PATCH RJ45", available in different lengths) but you can also make your own cables with CAT5e cable and RJ45 connectors you can buy from any computer shop. However we like to warn you that making your own cables is not easy and requires special tools and some experience! [. . . ] 250V 1A slow blow (20mm glass) 250V 2A slow blow (20mm glass) 1x zone 60W = 60Watt 2x zone 60W = 120Watt max. = 48pcs) 3pin XLR male / female 2 to max 11 channels (depends on working mode) see drawings 1, 2kg 2, 1kg Every information is subject to change without prior notice You can download the latest version of this user manual on our website: www. Use DOWN and UP buttons to select (display always on) or (display off when not used). (or automatically return to the main functions without any change after 8 seconds) Press the MENU button for about 2 seconds to save the setting and return to running mode, press shortly to return without saving. [. . . ]