User manual BEGLEC IMOVE 8W MOVING WASH

[. . . ] iMove 8W Moving Wash Innovation , Quality , Performance WWW. BEGLEC. COM 7. Fixture Cleaning The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt on the unit's optics. Clean the internal optics at least every 30/60 days. TABLE OF CONTENTS 1. [. . . ] Because of its high internal pressure, there might be a risk that the Discharge lamp would explode during operation. The lamp emits intense UV radiation which is harmful to the eyes and skin. The high luminance of the arc can cause severe damage to the retina if looks directly at the lamp. Always switch off the main supply and never handle the lamp or luminaries when is hot. If this happens, clean the lamp with denatured alcohol and wipe it with a lint free cloth before installation. When burning, the lamp operates at high pressure and there is a slight risk of arc tube rupture. The risk increases with age, temperature and improper handling of the lamp. Make sure the lamp is located in the center of the reflector for the best spot. 7A i. ) Channel 14 ­Pre-programmed show pattern: 1. ) DMX value 0-31, the fixture is still controlled by DMX control . 2. ) For DMX Value above 31, all the DMX control will be invalid . The fixture will run the pre-programmed show patterns(Pan/Tilt movement). ii. ) Channel 15-Pre-programmed beam pattern: One can select the beam pattern only when the pre-programmed show pattern is activated. iii. ) For DMX Reset, put DMX value of CH-8 & CH-16 to 255. 5. 4. Control Panel Display To show the various menus and the selected functions . LED 8A DMX MASTER SLAVE SOUND Button MENU DOWN UP ENTER Remote controller input On On On Flashing DMX input present Master mode Slave mode Sound activation To select the programming functions To go backward in the selected functions To go forward in the selected functions To confirm the selected functions By connect to the 1/4" microphone jack to control the unit for Stand by, Function, and Mode function. DMX input/output For DMX512 link, use 3-pin XLR plug cable to link the unit together. 4. 2. Main Function To select any of the pre-set functions, press the MENU button up to when the required one is shown on the display. Once the required mode has been selected, press the ENTER button to setup or it will automatically return to the main functions without any change after idling 8 seconds. The main functions are shown below: Stand by Blackout the unit Strobe 1. Two-light strobe X/Y moving show pattern Color selection selection ( Show 1 ~ Show 4 ) Please refer to 4. 2. Once the address has been selected, press the ENTER button to setup or automatically return to the main functions without any change after 8 seconds. To go back to the functions without any change press the MENU button again. channels of each fixture in the chain. Please refer to the following diagram to address your DMX512 channel for the first 4 units. [. . . ] Pan Inversion Press the MENU button up to when the is shown on the display. Pressing ENTER (normal) or Display normal mode for the fixture putting on the floor. Display inversion mode for the fixture fixing under ceiling. button and the display will blink. Once the mode has been selected, press the ENTER button to setup or automatically return to the main functions without any change after 8 seconds. [. . . ]