User manual BEGLEC IMOVE 250W MOVING WASH

[. . . ] Don't touch the housing bare-hand during its operation, and allow about 15 minutes to cool down before replacing bulb or serving, as the unit could be very hot. In the event of serious operating problem, stop using the unit immediately. Repairs carried out by unskilled people can lead to damage or malfunction. Always use the same type spare parts. Warning To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or moisture. [. . . ] Use DOWN and UP button to select the button and the display will blink. Use DOWN and UP button to select the been selected, press the ENTER button to setup or automatically return to the main functions without any change after 8 seconds. To go back to the functions without any change press the MENU button again. (pan inversion) mode. Once the mode has been selected, press the ENTER button to setup or automatically return to the main functions without any change after 8 seconds. To go back to the functions without any change press the MENU button again. Show 3 mode - Fixture is placed on the speaker, The spot is always projecting to the audience's direction; i. e in front of the stage. Tilt movement angle: 90° ( vertically, front 75°; back 15° ) Slave Mode Press the MENU button up to when the is shown on the display. Pressing ENTER (normal) Tilt movement angle: 90° ( 60° above horizon; 30° Press the MENU button up to when the or is shown on the display. Once the mode has been selected, press the ENTER button to setup or automatically return to the main functions without any change after 8 seconds. To go back to the functions without any change press the MENU button again. Led Display Press the MENU button up to when the (Led on) or is showing on the display. Once the mode has been selected, press the ENTER button to setup or automatically return to the main functions without any change after 8 seconds. To go back to the functions without any change press the MENU button again. Display Inversion It is good for you to install the unit on the floor or under ceiling. Use the ENTER button to change to the mode 11- button and the display will blink. Once the mode has been selected, press the ENTER or button to setup or automatically return to the main functions without any change after 8 seconds. To go back to the functions without any change press the MENU button again. 10- (display inversion), It will automatically store after 8 seconds. To go back to the functions press Set DMX value of channel 8 and channel 16 to 255, then all channels of the unit will return to their standard home position. 4. 3 Home Postion Adjustment Press MENU button for at least 5 seconds into offset mode to adjust the home position, the functions are shown below: Self-Test Press the MENU button up to when the MENU button again. Ambient temperature of lamp Press the MENU button up to when the functions press the MENU button again. Fixture Hours Press the MENU button up to when the functions press the MENU button again. Lamp Display Press the MENU button up to when the or is blinking on the display. [. . . ] Check in the DMX cables run near or run alongside to high voltage cables that may cause damage or interference to DMX interface circuit. Check the unit that is not receiving DMX signal. C D C D A F E A B B H 2. The stepper motor might be damaged or the cable connected to the PCB is broken. The lamp is cutting out intermittently 2021G A Pay attention to the belt tension when install the belt. [. . . ]