User manual BEGLEC FX 700 V1.0

[. . . ] The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. [. . . ] Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Make sure that the fog fluid container is never empty during operation, this will damage the pump of the fogger. HANGING BRACKET: hanging bracket with two knobs on both sides to fasten the unit + mounting holes to fix a mounting hook. When the problem is solved, replace a damaged fuse with a fuse of the same type and electrical specifications. MAINS CABLE: to be plugged in a mains wall socket with earth connection. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. The minimum distance between fogger output and objects must be more than 1 meter. NEVER hold your hands close to the fogger output, the fog is very hot and can cause serious burnings !To protect the environment, please try to recycle the packing material as much as possible. Make sure that nobody can put their hands just in front of the output. plug the supplied remote in the "remote control" input (5) on the back of the unit. Don't insert or remove the remote while the fogger is connected to the mains!Make sure to plug the fogger in a mains wall socket with earth connection Switch the fogger on and wait for about 5 minutes. REMOTE CABLE: connect the special 3pin connector to the remote input on the back of the fogger (5). MANUAL FOGGING BUTTON: for as long as the green LED is on, you can press this button at any time to produce fog. Used with the optional wireless FC5 controller: Connect the special 3pin connector (1) to the remote input on the back of the fogger. [. . . ] Switch the fogger off Remove the nozzle (metal part where the fog leaves the fogger) Remove the fog liquid from the tank Fill the tank with about 1liter of a solution containing 80% distilled water and 20% white vinegar. Switch the fogger on and wait for about 8minutes (warm up time) Put the fogger in continuous operation mode until the tank is empty Put the nozzle back in place Remove the eventual residues of the cleaning solution and refill the tank with fog liquid. Remark: cleaning should be done outside; an awful smell is produced by the vinegar solution! [. . . ]