User manual BEGLEC CA-16 V1.0

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. To take full advantage of all possibilities, please read these operating instructions very carefully. This product meets the requirements of the current European and national guidelines. [. . . ] Condense sometimes prevents the unit from working at full performance or may even cause damages. â· Don't place metal objects or spill liquid inside the unit. If a foreign object enters the unit, immediately disconnect the mains power. â· Don't cover any ventilation openings as this may result in overheating. â· Prevent use in dusty environments and clean the unit regularly. â· Inexperienced persons should not operate this device. â· Always unplug the unit when it is not used for a longer time or before you start servicing. â· The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. â· Check that the available voltage is not higher than the one stated on the rear panel of the unit. â· The power cord should always be in perfect condition: switch the unit immediately off when the power cord is squashed or damaged. â· Never let the power-cord come into contact with other cables! â· This appliance must be earthed to in order comply with safety regulations. â· In order to prevent electric shock, do not open the cover. Always replace a damaged fuse with a fuse of the same type and electrical specifications! â· In the event of serious operating problems, stop using the appliance and contact your dealer immediately. â· Please use the original packing when the device is to be transported. [. . . ] â· Press the button again to switch off the corresponding output channel of the connected DMX switch pack. Example of a setup with CA-16 and four SW-416 switch packs: Every information is subject to change without prior notice DMX OUTPUT: used to connect one or more standard DMX switch packs. If you should use another adapter, please make sure that it has 9Vdc and minimum 800mA with + in the center. [. . . ]