User manual BEBE CONFORT MILOFIX

[. . . ] € UNIVERSAL ISOFIX SYSTEM in forward facing position (Gr1 / 9-18 kg), class size B1. Baby in the Bébé Confort MiloFix car seat: • In the rear-facing position, the MiloFix car seat is automatically placed in the maximum reclining position, therefore, the angle of recline handle cannot be used for safety reason. € Even a gentle impact on a vehicle can turn a child into a projectile. € For your own safety and that of your child, always put the child in the child car seat, however short your journey may be. [. . . ] €• When installing the seat in the rear-facing position, the belt of the top tether can turn one quarter turn according to the position of the anchorage point. € When installing the car seat, it is necessary to remove the headrest in order to put the top tether through correctly. € Warning: when installing the car seat, spaces between the base of the car seat and the vehicle seat are possible depending on the position of the anchorage points within the vehicle. € The user must always check that any luggage and other objects likely to cause injury to the occupant of the car seat in the case of impact are properly secured. WARNING: never combine two ISOFIX anchorage and car seat belt systems to install your child car seat. ATTENTION: in ISOFIX use the fitting clips for lower anchorage to the vehicle is not sufficient. It is essential to fix the “Top Tether” to the upper anchorage point recommended by the car manufacturer. €Fitting the MiloFix seat with additional tethers using the vehicle’s ISOFIX additional anchorage points. The ISOFIX anchors have been developed to obtain a safe and easy fixation of the child safety systems inside the car. Not all cars are equipped with these anchors although they are standard on more recent models. Consult the attached list of cars for which the car seat can be installed correctly (you can also consult additional updates of this list on the website www. Com)” 42 • The rigid parts and the plastic sections of a child restraint device should be positioned and installed in such a way that they cannot, when the vehicle is being used under normal conditions, become trapped under a moving seat or in the vehicle door. € Never modify the construction or the materials of the car seat and the seat belt without consulting the manufacturer. Do not replace the seat cover with a cover other than that recommended by the manufacturer, because it will have a direct effect on the functioning of the child restraint. € This child restraint is effective only if the instructions for use are respected. € Always fasten the child restraint even when the child is not sitting in it. € Never place heavy objects on the rear parcel shelf, to avoid the danger of projectiles in the event of an accident. € Always check that no part of the seat or the harness is trapped under a seat or in the vehicle door. If you encounter any installation problems due to the length of the vehicle seat belt, contact your distributor immediately. € If in any doubt about the correct installation or use of the system, the user is advised to contact the distributor or the manufacturer of the child restraining device system. [. . . ] • When the product has been repaired by a non-approved supplier. € When the product is not returned to the manufacturer with the original till receipt (issued by the retailer and/or importer). € When repairs have been carried out by a third party or a non-approved retailer. Warranty • When the defect was caused by incorrect or insufficient use or maintenance, neglect or impacts at the level of the textile and/or chassis. [. . . ]