User manual BAZOO SLIMBOARD QUICK GUIDE

[. . . ] To reduce the risk of fire, explosion, electric shock, or personal injury when using your hob, follow these basic safety precaution. Note Important 2_ using this manual SLIMBOARD_XSA_DG68-00348A-EN. indd 2 2011-06-07 6:47:02 safety instructions The safety aspects of this appliance comply with all accepted technical and safety standards. However, as manufacturers we also believe it is our responsibility to familiarize you with the following safety instructions. WARNING SAFETY INSTRUCTIONS ELECTRICAL SAFETY Be sure the appliance is properly installed and grounded by a qualified technician. Repairs carried out by unqualified individuals may cause injury or serious malfunction. [. . . ] · On natural, artificial stone, or ceramic tops, the snap action springs must be bonded in place with a suitable artificial resin or mixed adhesive. · Ensure that the seal is correctly seated against the work surface without any gaps. Additional silicon sealant must not be applied; this would make removal more difficult when servicing. · The ventilation gap between the worktop and front of the unit underneath it must not be covered. The surface temperature on the underside of the electric hob may exceeds 95°C. CAUTION To avoid hazard, under bench access must be restricted. 12_ installing the hob SLIMBOARD_XSA_DG68-00348A-EN. indd 12 2011-06-07 6:47:03 CONNECTING TO THE MAINS POWER SUPPLY Before connecting, check that the nominal voltage of the appliance, that is, the voltage stated on the rating plate, corresponds to the available supply voltage. The appliance also works perfectly on networks with AC 220 V~ or AC 240 V~. The hob is to be connected to the mains using a device that allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm, eg. The cable connections must be made in accordance with regulations and WARNING the terminal screws tightened securely. WARNING Once the hob is connected to the mains supply, check that all cooking zones are ready for use by briefly switching each on in turn at the maximum setting with suitable cookware. When the hob is powered on for the first time, all displays light and the child safety lock is activated. WARNING Pay attention (conformity) to phase and neutral allocation of house connection and appliance (connection schemes); otherwise, components can be damaged. If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. · Complete Bridge zone selector : Use this function to expand cooking zone into complete right side. 18_ parts and features SLIMBOARD_XSA_DG68-00348A-EN. indd 18 2011-06-07 6:47:06 SAFETY SHUTOFF If one of the cooking zones is not switched off or the heat setting is not adjusted after an extended period of time, that particular cooking zone will automatically switch itself off. Any residual warmth will be indicated with (for "hot") in the digital displays corresponding to the particular cooking zones. The cooking zones switch themselves off at the following times. Heat setting 1-3 4-6 7-9 10-15 Switch off After 6 hours After 5 hours After 4 hours After 1. 5 hours PARTS AND FEATURES If the Hob is overheated because of abnormal operation, And the Hob will be switched off. will be displayed. If cookware is unsuitable or too small or no cookware has been placed on the cooking zone, will be displayed. And after 1 minute the corresponding cooking zone will be switched off. Should one or more of the cooking zones switch off before the indicated time has elapsed, see the section "Troubleshooting". Other reasons why a cooking zone will switch itself off All cooking zones will immediately switch themselves off if liquid boils over and lands on the control panel. The automatic shutoff will also be activated if you place a damp cloth on the control panel. In both of these instances, the appliance will need to be switched on again using the main On/Off control sensor after the liquid or the cloth has been removed . RESIDUAL HEAT INDICATOR When an individual cooking zone or the hob is turned off, the presence of residual heat is shown with an (for "hot") in the digital display of the appropriate cooking zones. Even after the cooking zone has been switched off, the residual heat indicator goes out only after the cooking zone has cooled. You can use the residual heat for thawing or keeping food warm. WARNING As long as the residual heat indicator is illuminated, there is a risk of burns. If the power supply is interrupted, the symbol will go out and information about residual heat will no longer be available. This can be avoided by always taking care when near the hob. WARNING parts and features _19 SLIMBOARD_XSA_DG68-00348A-EN. indd 19 2011-06-07 6:47:06 TEMPERATURE DETECTION If for any reason the temperatures on any of the cooking zones were to exceed the safety levels, should this happen then the cooking zone will automatically reduce to a lower power level. [. . . ] Scratches or dark blemishes on the ceramic glass surface, caused, for example, by a pan with sharp edges, cannot be removed. However, they do not impair the function of the hob. HOB FRAME (OPTION) WARNING Do not use vinegar, lemon juice or scale remover on the hob frame; otherwise dull blemishes will appear. 1. Wipe and rub dry. TO AVOID DAMAGING YOUR APPLIANCE · · · Do not use the hob as a work surface or for storage. Do not operate a cooking zone if there is no pan on the hob or if the pan is empty. [. . . ]