User manual BAUMATIC BDW45 1

[. . . ] BDW45. 1 45 cm Fully integrated full height electronic dishwasher USER MANUAL FOR YOUR BAUMATIC BDW45. 1 45 cm Fully integrated full height electronic dishwasher information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference; for you or any person not familiar with the operation of the appliance. NOTE: This User Instruction Manual contains important DD 25/06/09 2 Contents Environmental note Important safety information Specifications Description of the appliance Using your dishwasher Before first use Filling with dishwasher salt Setting the water softener level Filling with rinse aid Setting the rinse aid level Filling with dishwasher detergent Loading the upper basket Adjusting the upper basket Loading the lower basket The cutlery basket Loading dishes and cutlery Program table Setting a wash program Changing a wash program At the end of a wash program Setting a delay start Rinse aid and salt indicator neons Cleaning and maintenance The filter system Cleaning the filters Cleaning the spray arms Cleaning the control panel Cleaning the door Error code failure system General troubleshooting Installation Aperture requirements Preparing and connecting the furniture door Adjusting the tension of the door spring Connecting to the mains water supply Connecting to the water outlet Connecting to the power supply Applying the condensation strip Positioning the dishwasher Levelling the appliance Securing the dishwasher Before first use Contact details 4 5­7 8-9 9 - 10 10 10 11 12 13 13 14 15 15 17 18 19 20 21 21 22 22 23 - 23 ­ 12 - 14 - 17 - 19 - 22 23 - 26 23 - 24 24 25 25 26 26 ­ 28 28 ­ 30 30 30 31 33 34 35 35 36 37 38 39 39 41 - 39 - 31 ­ 32 - 36 - 37 - 40 3 ENVIRONMENTAL NOTE disconnect it from the power supply. Disable the door lock to make sure that children cannot get stuck inside the appliance. Note: Before discarding an old appliance, switch off and o The packaging materials that Baumatic uses are environmentally friendly and can be recycled. o Please discard all packaging material with due regard for the environment. [. . . ] 19 Program table Program Cycle Program information For normally soiled loads, such as pots, plates, glasses and lightly soiled pans, standard daily cycle. For the heaviest soiled loads, such as pots, pans, casserole dishes and dishes that have been sitting with dried food on them for awhile. For lightly soiled loads, such as plates, glasses, bowls and lightly soiled plates. To rinse dishes that you plan to wash later that day. Description of cycle Pre-rinse Pre-rinse Wash (50°C) Rinse Rinse (65°C) Drying Pre-rinse Pre-rinse (50°C) Wash (60°C) Rinse Rinse (70°C) Drying Pre-rinse Wash (50°C) Rinse Rinse (65°C) Drying Rinse Rinse (65°C) Drying Pre-rinse Wash (40°C) Rinse Rinse (65°C) Wash (40°C) Rinse Rinse (55°C) Pre-rinse Detergent pre/main 5 grams (pre-rinse) 22 grams (main wash) Program times* 117 minutes Normal ** Intensive 5 grams (pre-rinse) 22 grams (main wash) 127 minutes Economy 22 grams (main wash) 102 minutes Rinse 50 minutes Glass 15 grams (main wash) 70 minutes Rapid 15 grams (main wash) 45 minutes 7 minutes Soak * The wash program times that are quoted are intended as a guide only. ** Normal is the testing program for EN 50242. 20 Setting a wash program Make sure that the before first use section has been followed. o Pull out the top and bottom baskets, then load them in accordance with the loading instructions. o IMPORTANT: Wait for 5 seconds before pressing the program selection button, otherwise the appliance may not function correctly. o Press the program selection button to choose an appropriate wash program for the load that you are washing. The relevant program indicator neon will light to show which program you have selected. o After a few seconds, you will hear the appliance begin to fill with water and the wash program will have started. Changing the wash program IMPORTANT: This should only be attempted when the cycle has only just started, otherwise the detergent tablet may have already released or you could have hot water escaping. o Slightly open the door of the appliance and turn off the power using the ON/OFF button. o Turn the appliance on by using the ON/OFF button and wait for 5 seconds before pressing the program selection button. 21 o Press and hold down the program selection button for 3 seconds to cancel the wash program. Then use the program selection button to choose the correct wash program. o After a few seconds, you will hear the appliance begin to fill with water and the wash program will have started. At the end of a wash program o The time display will flash for 8 seconds and a buzzer will sound. o If you have used the delay start mode, the time display will flash for 8 seconds but the buzzer will not sound. o Use the ON/OFF button to switch the dishwasher off and unload the dishwasher. Setting a delay start It is possible to delay the start of the wash program for up to a maximum of 24 hours. o Pull out the top and bottom baskets, then load them in accordance with the loading instructions. o IMPORTANT: Wait for 5 seconds before pressing the program selection button, otherwise the appliance may not function correctly. o Press the program selection button to choose an appropriate wash program for the load that you are washing. [. . . ] o Ensure that the underneath of the worktop is clean before sticking the strip to it. o IMPORTANT: Failure to attach the condensation strip could result in damage to your worktop. Positioning the dishwasher o Place the feet of the dishwasher into the slide rails. o Carefully slide the dishwasher back into position, underneath the worktop. 37 Levelling the appliance o IMPORTANT: Your dishwasher must be level for it to operate properly. [. . . ]