User manual BAUKNECHT XHPC155XL INSTALLATION INSTRUCTION

[. . . ] To avoid possible damage to the washer, the transport bolts on the back of the washer must be in place before installing the pedestal. To avoid suspension and structural damage, your washer must be properly set up for relocation by a certified technician. Slowly loosen the fill hoses at the faucets to relieve the water pressure. [. . . ] Thread a jam nut onto each foot so that the nut is 1" (25 mm) above the foot base. Thread the feet into the threaded holes located at each corner of the pedestal, until the jam nuts touch the bottom of the pedestal. Pedestal box To avoid floor damage and ease installation and handling, unfold the empty pedestal box flat and place it next to the washer. The front of the pedestal cabinet should align with the washer cabinet as shown below. Leave a space of about 3/8" (10 mm) between the screw head and the bottom of the washer. Front View from above Position the pedestal toward the front of the washer and install the two remaining hex-head sheet metal screws. Locate the leveling feet in the package removed from the pedestal drawer. Thread a jam nut onto each foot so that the nut is 1" (25 mm) above the foot base. Thread the feet into the threaded holes located at each corner of the pedestal, until the jam nuts touch the bottom of the pedestal. Pedestal box To avoid floor damage and ease installation and handling, unfold the empty pedestal box flat and place it next to the dryer. The front of the pedestal cabinet should align with the dryer cabinet as shown below. Front view from above Partially install two of the #12 x 5/8" hex-head sheet metal screws in the indicated holes. Leave a space of about 3/8" (10 mm) between the screw head and the bottom of the dryer. Position the pedestal toward the front of the dryer and install the two remaining hex-head sheet metal screws. [. . . ] When the washer/dryer is level, use a 9/16" open-end wrench to securely tighten all four jam nuts against the pedestal. Not Level level Not Level If not level, adjust pedestal feet up or down, repeating as necessary. Pull both drawer slides out and reassemble the drawer to the drawer slides with the two hex-head screws. [. . . ]