User manual BAUKNECHT WATE 9375

[. . . ] Contents Before Using the Washing Machine First Wash Cycle Precautions and General Recommendations Description of the Washing Machine Preparation of the Washing Detergents and Additives Programme Selection Cleaning the Foreign Body Trap Draining Residual Water Care and Maintenance Troubleshooting Guide After-Sales Service Transport and Handling Installation 21 Before Using the Washing Machine 1. Remove the packaging and check a. Cut and remove the shrinkwrap. Remove the bottom protection by tilting and turning the appliance on one rear bottom corner. e. Remove the blue protective film from the panel (depending on model). · After unpacking, make sure that the washing machine is undamaged. [. . . ] The indicator lamp of the "Start/Pause" button flashes. Note: the "Start Delay" and "Prewash" options cannot be selected after a change of programme. 2. The newly selected programme will start at the washing position where the previous programme was interrupted. Note: Do not add detergent for the new programme. Programme interruption/ pause If, for any reason, you want to interrupt the programme for a certain time and continue it later: 1. After the desired pause, press the "Start/Pause" button again. Press the "Start/Pause" button to start the "Drain" programme. Cancel programme If the current programme has to be terminated prematurely and cancelled, proceed as follows: 28 Cleaning the Foreign Body Trap The appliance is provided with a self-cleaning pump. The foreign body trap keeps objects like buttons, coins, safety-pins etc. Turn the foreign body trap slowly anti-clockwise until the grip is vertical; do not remove it as yet. Make sure the pump impeller (in the housing behind the foreign body trap) is not obstructed. Insert the foreign body trap again and screw it fully down in a clockwise direction to the stop (until the grip is horizontal). 10. Pour 0. 5 litres of water into the machine via the drum and check that water does not leak from the foreign body trap. Check the foreign body trap if the appliance is not draining correctly or if it fails to perform spin cycles. Check the foreign body trap regularly, two or three times a year and clean it if necessary. IMPORTANT: Make sure the water has cooled before emptying the foreign body trap. 29 Draining Residual Water When should I drain residual water (draining problem)?· If the appliance is installed in a room subject to sub-zero temperatures. Turn off the tap, disconnect the water supply hose from the machine and allow the water to drain into a basin. Open the foreign body trap, let the water drain into a small shallow basin and close the trap. Release the drain hose then open the fixing clip located at the rear of the machine (see arrow A). Fix the drain hose again with the clip and replace it with the U-bend. Important: · After draining the residual water, screw on the machine's water supply hose by hand. Check watertightness of appliance connections by turning the tap completely on. A Care and Maintenance Detergent dispenser 1. Replace the dispenser by locating the bottom tabs in the lid holes and pivot until both of the upper buttons lock. Note: ensure that the detergent dispenser is correctly reinstalled. 30 Water inlet hose filter Check and clean regularly (at least two or three times a year). [. . . ] Before using the appliance, the transport bracket at the back MUST be removed. Unscrew the two screws A and the four screws B with a flat screwdriver or a No. Remove the two seals C from the hose holder and clip them into the openings of the machine D. Note: do not forget to replace and tighten the four outer screws. A D B 1 1 1 2 C 4 D 4 35 Adjust the feet Install the appliance on a level surface, near to electrical, water and drain connections. [. . . ]