User manual BAUKNECHT KGNA 305

[. . . ] · The appliance will automatically start when knob (2) is not on position OFF. · The inside light switches on when the refrigerator door is opened. Important: · There is no need to adjust the thermostat knob as the temperature is factory set to ensure the correct storage temperature for fresh foods at ambient temperatures between +20°C and +25°C. · After being switched on, the refrigerator needs approximately 2 hours to reach the correct temperature to store a typical volume of food in the refrigerator compartment. [. . . ] · All appliances equipped with an ice maker or water dispenser must be connected to a mains water supply that delivers potable water only (with water pressure between 1. 7 and 8. 1 bar (25 and 117 PSI)). Ice makers and/ or water dispensers not directly connected to a mains water supply must be filled with potable water only. · Install and level the appliance on a floor strong enough to take its weight and in an area suitable for its size and use. · Install the appliance in a dry and wellventilated place The appliance is set for operation at specific ambient temperature ranges, according to the climatic class indicated on the data plate: The appliance may not work properly if it is left for a long period at a temperature above or below the indicated range. Climatic class SN N ST T Amb. (°F) From 50 to 90 From 61 to 90 From 64 to 100 From 64 to 110 · Be careful not to damage the floors when you move the appliance (e. g. · Do not use mechanical devices or any means other than those recommended by the manufacturer to speed up the defrosting process. · Do not use electrical appliances inside the freezer compartments, unless such appliances are specifically recommended by the manufacturer. · This appliance is not designed for use by young children or the infirm. · To avoid the risk of children being trapped and therefore suffocating, do not allow them to play or hide inside the appliance. · The power cable may only be replaced by an authorized person. · It must be possible to disconnect the appliance from the mains by unplugging it or by means of a two-pole switch fitted upline of the socket. · Ensure that the voltage indicated on the appliance data plate corresponds to the domestic supply voltage · Do not ingest the contents (non-toxic) of the ice packs (if provided). 16 INSTALLATION Location · Install the appliance in a dry, well-ventilated place. · Install and level the refrigerator on a floor strong enough to take its weight and in an area suitable for its size and use. · After installation, make sure that the appliance is not standing on the power supply cable. · When not in use, just pull it upward and then push it backward. · To remove the shelf, just slide the side locks (if available) as in the picture, and pull it toward you. · After replacing the extra shelf, slide the side locks in its original position. 1 2 SLIDING GLASS SHELVES (depending on the model) Your refrigerator is provided with sliding glass shelves which make it easier for you to access foods stored at the shelves or at lower shelves. · The edges of the shelves prevent split liquids from going to other compartments. · In some models the maximum load of glass shelf is given ( ) 3 Changing the position of shelves: Your refrigerator allows you to change the position of shelves according to your needs. · Keep the lock pressed down ad shown in the picture detail, and pull the shelf frontward until it is released. · Remove the rails as in the picture and place them where you wish. · To place the rails observe the inscrition " " written on the rail. [. . . ] If it has not, disconnect the appliance from the power supply and wait for about an hour before switching on again. If the problem persists after this course of action, contact After-sales Service. Specify: · the nature of the problem, · the model, · the Service number (the number after the word SERVICE on the data plate on the inside of the appliance), · your full address, · your telephone number and area code. Note: The direction of door opening can be changed. If this operation is performed by After-sales Service it is not covered by the warranty. [. . . ]