User manual BARTSCHER A190.043 V6-1010

[. . . ] This symbol highlights tips and information, which have to be followed for an efficient and trouble-free operation of the device. All the information and instructions in this manual take into account standard safety regulations, current levels of technical engineering as well as the expertise and experience we have developed over the years. The instruction manual was translated with all due care and attention. If the delivery consists of a special model, the actual scope of delivery may differ from the descriptions and illustrations in this manual. [. . . ] If you liked to dispose the packing, consider the regulations applicable in your country. In case any part is missing please contact our customer service center immediately. Keep the package closed until installation and under consideration of the outside indicated positioning- and storage markings. Packages should be stored under consideration of the following: Do not store outdoors. In case of longer storage (> 3 months) make sure you check the state of the packaging and the parts regularly. Top hotplate Toggle switch top hotplate ON/OFF Toggle switch coffee machine ON/OFF Water container Bottom plate Stainless steel thermo jug Filter basket Cover flap for filling in cold water Control lamp red (status indikator) Water drain screw Power supply cable RESET-button Bartscher basket filter paper (1000 Filter papers per box) The device must only be connected to a properly installed single socket with protective contact. Do not use the device in case it does not function properly, has been damaged or dropped. Do not use any accessory or spare parts that have not been recommended by the manufacturer. These can be dangerous for the user or lead to damages of the device or personal injury, and further, the warranty expires. Keep away the cable from operating range and do not dunk it into water. Before installation the local power grid specification should be compared with that of the device (see type label). Place the device on top of an even and safe surface which supports the weight of the device and is not heat sensitive. Not at any time should you place the device on an inflammable surface (such as: table cloth, carpet, etc. You must not position the device near open fireplaces, electric ovens/arc furnaces, furnaces/electric heaters or other heat sources. Only connect the device directly to the wall socket; do not use any extension cords or power strips. Place the device so that the plug is easily accessible and can be quickly removed from its socket in case of necessity. Prior to first use, run 2 to 3 portions of water without coffee through the coffee machine in order to rinse the device (, , Brewing coffee", steps 1-8). After first use (depending on the construction of the system), a small amount of water will always remain in the reservoir. Always fill the water container with an amount of water equal to the capacity of the thermo jug included with the coffee machine. the amount of coffee brewed will be the same as the amount of water poured. If too much water is poured into the water container, excess water will drain out through the flow hose. Prior to use, rinse the thermo jug and filter basket with warm water and a mild cleaning agent, then rinse with clean water and dry thoroughly. [. . . ] The above described problem cases are given for orientation and as examples. Should these or similar problems occur, please turn off the machine immediately and don´t use it anymore. In order to check and repair your machine, please contact a qualified expert or the manufacturer immediately. At the end of its service life the discarded device has to be disposed in accordance with the national regulations. [. . . ]