User manual BARTSCHER A151.5001

[. . . ] All the information and instructions in this manual take into account standard safety regulations, current levels of technical engineering as well as the expertise and experience we have developed over the years. The instruction manual was translated with all due care and attention. If the delivery consists of a special model, the actual scope of delivery may differ from the descriptions and illustrations in this manual. This is also the case for special orders or if the device has been modified in line with new technology. [. . . ] The manufacturer and/or authorized parties do not accept any claims resulting from damage caused by using the device not according to its intended use. In case of visible damage, do not accept or accept the delivery with reservation only. note the extent of damage on the carrier's bill of delivery and notify us of any recorded damage. Hidden damages should be reclaimed immediately after detection, as claims for damages can only be asserted within the effective period for complaints. Please do not throw away the covering carton of your device as it might be useful for storage purposes, when moving or, in case of damages, when the device must be sent back to a repair center. The outer and inner packing material should be removed completely from the device before installation. Observe the regulations applicable in your country when disposing of the packaging. In case any part is missing, please contact our customer service center immediately. Keep the package closed until installation and under consideration of the positioningand storage markings indicated on the outside. Packages should be stored under consideration of the following: Do not store outdoors. In case of longer storage (> 3 months), make sure you check the state of the packaging and the parts regularly. The device must only be connected to a properly installed single socket with protective contact. â· See that the cable does not touch any heat sources or sharp edges. Do not use the device if it does not function properly, has been damaged or dropped. Do not use any accessory or spare parts that have not been recommended by the manufacturer. These can be dangerous for the user, or lead to damage of the device or personal injury, and furthermore invalidate the warranty. Keep the cable away from operating range and do not dunk it into water. Before installation, the local power grid specification should be compared with that of the device (see type label). Place the device on top of an even and safe surface which supports the weight of the device and is not heat sensitive. Not at any time you should place the device on top of an inflammable surface (such as: table cloth, carpet, etc. [. . . ] O After the cleaning procedure you should use a soft and dry cloth to wipe dry and polish the surface. O Make sure the device has been cleaned and dried properly for further usage. O Check the mains lead from time to time to ensure it is not damaged in any way. A damaged cable must immediately be replaced by customer service or a qualified electrician to avoid dangers. [. . . ]