User manual BARTSCHER A120784

[. . . ]  If the water inlet hose is not long enough, contact a specialist store or an authorised serviceman. 14 Connecting the drain hose  Do not use extensions or multiple sockets. Connect the drain hose, without bending it, to a draining duct or a wall drain situated between 65 and 100 cm from the floor; GB Installation  The power supply cable must never be bent or dangerously compressed.  The power supply cable must only be replaced by an authorised serviceman. [. . . ] 5 bar) drum capacity 40 litres up to 500 rpm Troubleshooting programme 2; temperature 60°C; run with a load of 5 kg. This appliance is compliant with the following European Community Directives: - 73/23/CEE of 19/02/73 (Low Voltage) and subsequent amendments - 89/336/CEE of 03/05/89 (Electromagnetic Compatibility) and subsequent amendments  The washing machine should not be installed in an Service  When the washing machine is installed, the mains socket must be within easy reach. TEMPERATURE knob: to set the temperature or the cold wash cycle (see page 18). Remember that this dial should be turned in a clockwise direction and only when the machine is off. After having removed the freshly cleaned washing, leave the door open to allow air circulation inside the drum. Always disconnect electricity at the socket and turn off the water supply. GB Installation Programme table Type of fabric and degree of soil Program- Tempemes rature Detergent Cycle Fabric length Description of wash cycle softener pre(minutes) wash wash Description Cotton Extremely-soiled whites (sheets, tablecloths, etc. ) Rinse Treatment with softeners Spin cycle 1 2 2 2 3 3 4 90°C 90°C 60°C 40°C 60°C 40°C 40°C • • • • • • • • • • • • • • • • • 150 140 140 140 115 115 95 Pre-wash, wash cycle, rinse cycles, intermediate and final spin cycles Wash cycle, rinse cycles, intermediate and final spin cycles Wash cycle, rinse cycles, intermediate and final spin cycles Wash cycle, rinse cycles, intermediate and final spin cycles Wash cycle, rinse cycles, intermediate and final spin cycles Wash cycle, rinse cycles, intermediate and final spin cycles Wash cycle, rinse cycles, intermediate and final spin cycles Rinse cycles, intermediate and final spin cycles Rinse cycles with automatic softener intake, intermediate and final spin cycles Draining and final spin cycle Wash cycle, rinse cycles, anti-crease or delicate spin cycle Wash cycle, rinse cycles, anti-crease or delicate spin cycle Wash cycle, rinse cycles, anti-crease or delicate spin cycle Wash cycle, rinse cycles, anti-crease or delicate spin cycle Wash cycle, rinse cycles, anti-crease or delicate spin cycle Rinse cycles, anti-crease or delicate spin cycle Rinse cycles with automatic introduction of softener, anti-crease or delicate spin cycle Draining and delicate spin cycle Wash cycle, rinse cycles, anti-crease or delicate spin cycle Rinse cycles, anti-crease or delicate spin cycle Rinse cycles with automatic introduction of softener, anti-crease or delicate spin cycle Draining and delicate spin cycle Draining without spin cycle Programmes Detergents Synthetics Heavily-soiled resistant colours (baby linen, etc. ) Heavily-soiled colour synthetics Heavily-soiled delicate colour synthetics Soiled colour synthetics Delicate colour synthetics (all types of slightly soiled garments) Rinse Treatment with softeners Spin cycle 5 5 5 6 7 Precautions 60°C 50°C 40°C 50°C 40°C • • • • • • • • • • • • 85 85 85 75 65 Care Troubleshooting Delicates Wool (machine-washable) Rinse Treatment with softeners Spin cycle Draining 8 40°C • • • • 55 Service Notes for the description of the Anti-crease function, please see page 18. 17 Personalisations GB Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 17). Setting the temperature Functions Per attivare le funzioni premere il tasto relativo alla funzione desiderata, secondo la tabella sottostante: Function Effect Reduces water consumption during the rinse cycles. • Disposing of an old washing machine: before scrapping your appliance, cut the power supply cable and remove the appliance door. General safety • This appliance has been designed for nonprofessional, household use and its functions must not be changed. • This washing machine should only be used by adults and in accordance with the instructions provided in this manual. • Never touch the washing machine when barefoot or with wet or damp hands or feet. • Do not pull on the power supply cable to unplug the appliance from the electricity socket. • Do not open the detergent dispenser while the appliance is in operation. • Do not touch the drain water as it could reach very high temperatures. • Never force the washing machine door: this could damage the safety lock mechanism designed to prevent any accidental openings. • In the event of a malfunction, do not under any circumstances touch internal parts in order to attempt repairs. • Always keep children well away from the appliance while in operation. • Should it have to be moved, proceed with the help of two or three people and handle it with the utmost care. [. . . ] Possible causes/Solution: • The appliance is not plugged into the socket, or not enough to make contact. • The drain hose is not fitted between 65 and 100 cm from the floor (see page 15). If the problem persists even after these checks, turn off the water tap, switch the appliance off and call for Assistance. If the dwelling is on one of the upper floors of a building, there may be drain trap problems causing the washing machine to load and unload water continuously. [. . . ]