User manual BARTSCHER 900002-224

[. . . ] If it is placed on a fitted or loose carpet, adjust the feet in such a way as to allow enough room for ventilation beneath the washing machine. Remove the four protective screws and the rubber washer with the respective spacer, situated on the rear of the appliance (see figure). Keep all the parts: you will need them again if the washing machine needs to be moved to another location. Insert seal A into the end of the inlet hose and screw the latter onto a cold water tap with a 3/4 gas threaded mouth (see figure). [. . . ] Take out your laundry and leave the appliance door ajar to make sure the drum dries completely. 5 Wash cycles GB Table of wash cycles Wash cycles Description of the wash cycle Max. Mix 30': To refresh lightly soiled garments quickly (not suitable for wool, 5 silk and clothes which require washing by hand). Mix 15': To refresh lightly soiled garments quickly (not suitable for wool, 6 silk and clothes which require washing by hand). Partials wash cycles Rinse Spin Light spin Drain no spin For all Test Institutes: 1) Test wash cycle in compliance with regulation EN 60456: set wash cycle 7 with a temperature of 60°C. 2) Long wash cycle for cottons: set wash cycle 2 with a temperature of 40°C. 3) Short wash cycle for cottons: set wash cycle 3 with a temperature of 40°C. A high-temperature hygienic wash cycle (over 60°C) which requires the use of bleach. Pour the bleach, the detergent and the additives into the relevant compartments (see paragraph entitled “Detergent dispenser drawer”). This is a silent cycle which can be run at night, when the electricity prices are lower. At the end of the cycle the machine stops while there is still water in the drum; to spin and drain the laundry press the START/PAUSE button; alternatively the machine will perform the spin cycle and drain the water automatically after 8 hours. Wash cycles 2, 3, 7, Pour the bleach into compartment 4; pour the detergent and softener into the corresponding compartments, then select one of the abovementioned wash cycles. Load balancing system Before every spin cycle, to avoid excessive vibrations and to distribute the load in a uniform manner, the drum rotates continuously at a speed which is slightly greater than the washing rotation speed. If, after several attempts, the load is not balanced correctly, the machine spins at a reduced spin speed. If the load is excessively unbalanced, the washing machine performs the distribution process instead of spinning. To encourage improved load distribution and balance, we recommend small and large garments are mixed in the load. 8 Precautions and tips  This washing machine was designed and constructed in accordance with international safety regulations. The following information is provided for safety reasons and must therefore be read carefully. Saving energy and respecting the environment Saving on detergent, water, energy and time • To avoid wasting resources, the washing machine should be used with a full load. A full load instead of two half loads allows you to save up to 50% on energy. Avoiding it will save on detergent, time, water and between 5 and 15% energy. • Treating stains with a stain remover or leaving them to soak before washing will cut down the need to wash them at high temperatures. [. . . ] Reposition the panel, making sure the hooks are securely in place before you push it onto the appliance. Cleaning your appliance The exterior and rubber parts of your appliance can be cleaned with a soft cloth soaked in lukewarm soapy water. Caring for your appliance door and drum • Always leave the appliance door ajar to prevent unpleasant odours from forming. Cleaning the pump The washing machine is fitted with a self-cleaning pump that does not require any maintenance. [. . . ]