User manual BARTSCHER 900002

[. . . ] All the information and instructions in this manual take into account standard safety regulations, current levels of technical engineering as well as the expertise and experience we have developed over the years. The instruction manual was translated with all due care and attention. If the delivery consists of a special model, the actual scope of delivery may differ from the descriptions and illustrations in this manual. This is also the case for special orders or when the device has been modified in line with new technology. [. . . ] Please do not throw away the covering carton of your device as it might be useful for storage purposes, when moving or, in case of damages, when the device must be sent back to a repair center. The outer and inner packing material should be removed completely from the device before installation. If you liked to dispose the packing, consider the regulations applicable in your country. In case any part is missing please contact our customer service center immediately. Keep the package closed until installation and under consideration of the outside indicated positioning- and storage markings. Packages should be stored under consideration of the following: Do not store outdoors. In case of longer storage (> 3 months) make sure you check the state of the packaging and the parts regularly. Stainless steel inside and outside adjusted, 35° ­ 60°C 230 V 50 Hz 200 W Subject to technical changes and alterations!The device must only be connected to a properly installed single socket with protective contact. Do not use the device if it does not function properly, has been damaged or dropped. Do not use any accessory or spare parts that have not been recommended by the manufacturer. These can be dangerous for the user, or lead to damage of the device or personal injury, and furthermore invalidate the warranty. Keep the cable away from operating range and do not dunk it into water. When the unit is in use, never touch the spiral screws or any other moving parts. Before installation, the local power grid specification should be compared with that of the device (see type label). Clean the worm screw (2), the tower (3), the top (3a) and the lower bowl (4) with washing liquid and rinse them with clean water and then dry them. Not at any time should you place the device on an inflammable surface (such as: table cloth, carpet, etc. You must not position the device near open fireplaces, electric ovens/arc furnaces, furnaces/electric heaters or other heat sources. Make sure that the wire is unavailable to children and is not an obstacle which can lead to stumbling. Place the device on a stable and even ground in the vicinity of a power socket. Level the fountain with the use of adjusted legs (A ­ 3 pieces) · Insert the power cable into a socket (the , , POWER" indicator will come on (10)). Only when the heating of the device is over, can liquid chocolate be poured in the lower bowl. [. . . ] As a rule, they are in the lower bowl near the sucking slit of the tower. The chocolate flows out irregularly and does not create the , , fountain effect". After adding a new portion of chocolate or other ingredients its outflow is stopped. At the end of its service life the discarded device has to be disposed in accordance with the national regulations. [. . . ]