User manual BARTSCHER 700605

[. . . ] This instruction manual contains information about the installation, operation and maintenance of the device and should be consulted as an important source of information and reference guide. Awareness of the safety instructions and instructions for use in this manual will ensure the safe and correct use of the device. In addition to the information given here, you should comply with any local Health and safety Controls and generally applicable safety regulations. The instruction manual forms part of the product and should be kept near the device and easily accessible for anyone carrying out the installation, servicing, maintenance or cleaning. [. . . ] Keep away the cable from operating range and do not dunk it into water. Before installation the local power grid specification should be compared with that of the device (see type label). The installation and maintenance of the appliance should only be carried out by trained personnel!Place the device on top of an even and safe surface which supports the weight of the device. Not at any time should you place the device on an inflammable surface (such as: table cloth, carpet, etc. Do not place the device in the vicinity of open sources of fire, electric cookers, furnaces or other sources of heat such as e. The heat can damage the surface of the device, as well as have a negative effect on the cooling power and increase the consumption of energy. Use the unit at ambient temperatures up to 32 °C; in spaces where temperatures are higher the efficiency of the unit may be reduced. To avoid damage to the compressor, do not tilt the device to an angle greater than 45° during setup or transport. Be careful when touching the condenser and doors, as damage to them will negatively impact the working of the device. If the unit has been improperly transported (in vertical or horizontal position), wait a minimum of 4 hours prior to activating the unit. Place the device in such a manner that there is a minimum of 10 cm between it and other objects, including walls, in order to ensure proper air circulation. Do not place the device where humidity or temperature are high as the device may be damaged. Before the first use the unit should stand for at least 2 hours before it is connected to the power source. Only connect the device directly to the wall socket; do not use any extension cords or power strips. Place the device so that the plug is easily accessible and can be quickly removed from its socket in case of necessity. Cooling with time regulation Cooling with temperature regulation via probe for measuring internal product temperature Freezing with time regulation Freezing with temperature regulation via probe for measuring internal product temperature Defrost FREEZING This indicator flashes when the freezing cycle is taking place, and lights up during the product conservation phase COOLING This indicator flashes when the cooling cycle is taking place, and lights up during the product conservation phase CONSERVATION This indicator lights up or flashes during the conservation phase TEMPERATURE This indicator lights up during the cooling cycle with temperature regulation via probe for measuring internal product temperature TIME This indicator lights up during the cycle with time regulation OFF This light comes on when the unit is turned off. FAHRENHEIT If the temperature indicator of the refrigerator-flash freezer is set to Fahrenheit, this indicator displays in red or green, depending on the colour of the light. CELSIUS If the temperature indicator of the refrigerator-flash freezer is set to Celsius, this indicator displays in red or green, depending on the colour of the light. The refrigerator-flash freezer is a unit capable in 90 minutes of reducing the temperature of comestibles from +70° to +3° with the cooling cycle, and in 240 minutes from C C +70° to -18° with the freezing cycle, along with which the thermal shock prevents the C C multiplication of bacteria, without changing the properties and quality of the frozen product. Insert the internal product temperature probe into the food product to a maximum depth of 2 ­ 3 cm. The display will show the current internal and hold until the display shows the word , , SOFT". [. . . ] To place the unit in STANDBY mode, press and hold for 3 seconds one of the following The refrigerator-flash freezer is prepared for a new rapid cooling cycle. To begin the next cooling cycle, press and hold for 3 seconds one of the following To turn the unit off, hold the START button for 3 seconds. The refrigerator-flash freezer can not be used as a normal refrigerator!Do not place food products in the unit which have a temperature above 70° as C, the high pressure alarm may be activated. [. . . ]